I'm not 100% sure, but try disconnecting both battery cables for 20 min. I know for sure that this works on older cars (I have done this on 1991 and 1993 Fords, etc...) hopefully it works for the new-gen 96+ computers.
As this should be an OBD1 system, removing the fuse or the positive battery cable for 10 minutes should reset the computer.
If the truck has distributerless ignition,disconnect battery for a few minutes,reconnect battery & drive the truck.The computer should reset timing within 10 miles.
remove the negative battery cable for about 30 minutes
Disconnect the negative cable on the battery! , it's very easy to do.
unhook the battery over night Unplug battery for half hour or so will reset it.
As far as I know, all computers can be reset by simply disconnecting and reconnecting the battery.
Disconnect the battery for 5 minutes.
The front wheels on a 1994 Ford Ranger lean inward due to the camber of the steering alignment. Adjustments can be made at a local tire shop.
underneth the intake underneth the intake
it is a manual 5 speed tranny.
As far as I know they can not be cleaned. Must be replaced.
It is about 18 inches up from the floor on the pass side of the cab. Find it and you will see how to reset it.
The evaporative system needs to reset. How?
Most full-service auto parts stores will read and reset your computer for FREE.
push the button down
where is the fuel reset button on a 1994 ford ranger Driver side trunk. behind plastic covering
disconnect the negative battery terminal to reset the pcm computer. disconnect it for at least 20 minutes
On a 1994 Ford Ranger : Check in the front passenger footwell , under the front edge of the carpet , mounted on the toe board just to the right of the transmission hump I believe that is where the fuel pump inertia switch is on a 1994 Ford Explorer
1994 ford ranger starts once in awhile
are there struts or shocks on the front of a 1994 ford ranger 2wd
you cant change it it is controled by the computer
how to reset the computer on a 1997 ford expedition
I might be wrong, but I think Mazda made the 1994 Ford Ranger $x4.
What size is the steel brake line tubing on a 1994 Ford Ranger