0
Seat belts happen to save our lives, everyday. When a person is in a car it is easy for a car accident, but we can prevent death by a seatbelt!!!
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you deactivate the seat belt minder in a 2004 ford escape?
here you go try going here first www.ebookspdf.com/automotives/3189/ford-escape-2001-owners-manual/and if that doesnt work try what i did get in like ur going somewhere without ur seat belt on put ur key in to the on position but dont turn it on wait till the seat belt light goes off then pull ur seat belt in and out 3 times then real fast turn ur light on then off then real fast pull ur seat belt in and out again 3 times then in 5 sec. pull it back in and out then the seat belt light should flash 4 times or so if u done it right hope this help.
How do you Turn off Seat belt alert in a Mercedes c280?
There is an electrical connector located under sear that connects to seat belt buckle, just disconnect it.
How do you unlock a seatbelt on a 2006 GMC Envoy?
You will need to allow the seat belt to retract completely, and if this does not work there is a problem with the actuater and you will need to take it in for service.
How do you replace your seat belt on a 99 Ford Explorer?
'96 Explorer Seat Belt Replacementhttp://www.seatcoverset.com/seatcovers-car_seat_cover.htmIn order to replace the driver side seat belt on a '96 Explorer, you must completely remove the drivers seat. Removing driver side seat belt: Use a 10mm socket/wrench to remove the two bolts securing the front of the seat to the floor. Move the seat as close to the steering wheel as possible to expose the rear of the sliding seat rails. Pop off the two covers at the end of each rail to expose two more 10mm bolts securing the seat to the floor. Next, remove the plastic cover with a Torx symbol on it at the rear of the seat belt guide rail. Removing the aforementioned cover will allow access to a large Torx bolt just below the rear of the center console. Remove this large Torx bolt, unplug any electrical wires below the seat, and remove the entire seat from the Explorer. With the seat out, you can use the same Torx wrench to unscrew the seat belt itself from the seat. Reassembly is the opposite of disassembly.
How do you reset the seat belt light on a 2004 ford f150?
Simply fastening your seat belt should put the light out. If you have a heavy object sitting on the passenger side seat like a tool box or such that could trick the light to come on. If not you have something disconnected or broken.
Will airbag work if seat belt is fastend?
Yeas it will
What to do if passenger seat does not always heat up?
The seat belt has to be ingaged for heater to work. The seatbelt has to be ingaged to work
How do you harness 3 in 1 car seat?
there are seat belt extenders that might work
Will air bag work if seat belt is not fastened?
Yes.
Why doesn't my seat belt alarm work?
depending on the vehicle, some seat belt alarms can be disabled theu settings in the vehicle,check owneres manuel for instructions how to do this or to undoe this
Are seat belts effective at low speeds?
no if you have the type of seat belt that you can keep pulling. They only work at higher speeds.
Why does your seat belt dinger come on while you have your seat belt latched?
Make sure you are not latching it into the buckle for the middle seat belt.
How do you Remove rear seat belt from vauxhall astra?
I can assume that you are talkin about centre belt cause they seem to be a big problem. First of all before you go there , there is a cable that runs from the seat belt unit to the catch that your seat clips into when you have laid it down. You will probably find that the seat catch is not engaged properly which stops a cable from retracting and allowing the seat belt mechanism to release. Try lubricating the latch at the rear of the seat and also slamming. This is a safety device so if your seat is not clipped in properly you cannot pull out seat belt. If this doesn't work - Unclip the the rear protector on the rear of your seat and you will see along the edge of the seat near the bottom ,where you undo the fabric from the seat . Fold the fabric at the top away after unclipping the plastic insert were the belt goes into the seat, You will see some screws holding a steel plate over the belt. Remove the plate - Look on the back of the seat on the steel part and there is a bolt holding seat belt in place , Undo this and abstract seat belt from between foam and release cable from seat belt..
What is the Seat Belt Law?
a seat belt law is a law of the road
Where is the seat belt sensor on 1998 Toyota?
Seat belt cilker.
How do you turn off the seat belt light?
wear a seat belt.
Who would you check for when inspecting seat belt on a forklift?
Damage to the belt itself, proper operation of all seat belt components, proper adjustment of seat belt.
