0
What else can I help you with?
What happens if you use a larger car battery then recommended?
If the battery will physically fit there is no problem using a higher capacity battery. Of course the voltage remains 12 Volts but there will a higher amperage available for a longer time should it be needed. This could actually be an advantage if there is ever difficulty starting, there will be more starter cranking time before the battery runs down. Think of it as having a larger gas tank, the gas is the same but there is more if needed.
Do bad spark plugs cause a battery to go down?
No, that will have no effect on the battery.
Jump the car or get a new battery?
If the battery is defective get a new battery. If you just left something on and ran it down, charge the battery and keep going.
If my car won't start and the lights are not coming on but it can be jumped off what may be my problem?
The battery is dieing down and you should go and get a new battery or get your battery charged
Starter is clicking while turning engine over slowly?
If it's turning over slowly but eventually starts, there is more than likely a problem with the battery. It may be drained down or discharged. You can perform a battery test on it to ensure that there is sufficient voltage and Cold Cranking Amps (CCA) to start the vehicle. It also would be good measure to perform a charging system test to be sure that the alternator is charging enough. If it was a fairly new battery, you may have to do a parasitic draw test to be sure that something isn't sucking juice out of the battery when it shouldn't be. Hope this helps.
Why does a battery gauge moves up and down while the engine is running?
A battery gauge "moves up and down" while running because of fluctuations in the voltage output of the circuit which it is connected to. This may be because of equipment on the circuit.
Why the battery gauge moves up and down while running?
Can be loose connections or the alternator is failing.
Why would the voltage gauge go all the way down?
The voltage gauge may drop to zero due to several reasons, including a dead battery, a blown fuse, or a malfunctioning alternator. Additionally, poor electrical connections or damaged wiring can disrupt the flow of electricity, causing the gauge to show a low or zero voltage reading. If the vehicle or device is not receiving power, the gauge will reflect that condition. It's essential to troubleshoot the electrical system to identify the root cause.
We have a gauge on our race car that requires 12 volts of power.Our cars battery is a 16 volt battery. Do we need to step down the voltage going to the gauge so it does not burn out?
Are you SURE your car is 16 volt?? I've seen 6 volt systems and 99.9% of the cars are 12 volt. So double check you numbers. I have NEVER seen a 16V battery in a car.
What would cause the voltage gauge to keep flickering up and down?
Either a bad ground to the guage itself or a bad voltage regulator in the alternator. While the enigine is running check the voltage at the battery it should be around 13.5volts if it constantly fluctuates then the voltage regulator is probably bad. Replace the alternator. Otherwise make sure your grounds are good.
Is there a way to lower down the voltage output of a battery charger?
A: Simply by adding a series resistor from the battery charger. WHAT VALUE? find the current required and use it to IR drop the voltage
What happens to voltage as it moves through a circuit?
Voltage breaks down and looses voltage but not power.The above answer is incorrect. In fact, the question is incorrect because voltage doesn't 'move through a circuit'.
When do the anodes and cathodes affect the voltage of a battery?
The anodes and cathodes affect the voltage of the battery all the time. Without them, the battery would not work. The anode provides the positive charge or current. The cathode provides the negative charge or electrons. Part of the anode is down in the battery and part serves as a terminal. Part of the cathode is down in the battery and part serves a a terminal.
What causes low voltage to the car starter?
A run down or nearing end of life battery. Dirty and/or loose battery connections.
Why would the battery light stay on after the ignition is turned off on a 1986 Nissan pickup?
The voltage reg is sticking and will run down the battery.
What do you do to change the voltage of a 12 volt battery to a 6 volt output?
To change the voltage of a 12-volt battery to a 6-volt output, you can use a voltage regulator or a step-down transformer. A voltage regulator will reduce the voltage to the desired 6 volts, while a step-down transformer will step down the voltage from 12 volts to 6 volts. Both options will help you achieve a stable 6-volt output.
Can you jump start a 6V battery of a 12V battery?
No, you should not jump-start a 6V battery with a 12V battery, as the higher voltage can damage the 6V battery and any connected electrical components. Instead, use a compatible 6V battery or a dedicated jump starter designed for that voltage. If necessary, you can use a 12V battery with a proper voltage regulator or a step-down converter to safely charge the 6V battery. Always follow safety precautions when working with batteries.
