answersLogoWhite

0


Best Answer

Assuming that your gauge is accurate, then you probably have a stuck thermostat in the open position that is not allowing the coolant to stay in the engine long enough to reach proper operating temp. Replace the thermostat or have a good mechanic do it for you.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: My Pontiace Fiero on runs about 110 degrees should be 195 degrees. How do I fix it?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

When developing film the temperature of the chemicals and water A is unimportant B should be kept at 68 degrees C depends on how many exposures are on the roll of film?

Actually, that's 68 degrees F, and that's only for black & white film. Color runs at 100.4 degrees F--or 20 degrees C (B&W) and 38 degrees C (color). As to the rest of your question...the temperature you use isn't changed by the number of exposures on the roll.


Where do the Equator and the Prime Meridian intersect?

The Prime Meridian of the world lies at 0˚ longitude.


What is an prime meridain?

There is only one Prime Meridian. It's an imaginary line on the surface of the earth that runs between the North and South Poles, and passes through the Royal Observatory in Greenwich, England. It's the official "Zero" line for east-west measurements; the 'longitude' of every place on earth is expressed as degrees "east or west of Greenwich". The USA ... not counting Alaska or Hawaii ... lies between roughly 67 degrees (Maine) to 124 degrees (California) west of the Prime Meridian.


Where does east end and west begin?

East and West technically don't end or begin, but there are lines of latitude that show where the Eastern and Western lines of latitude begin and end. The Prime Meridian, (0 degrees) runs through Greenwich, London, England, and any line of latitude away from it is labeled with the corresponding direction from the Prime Meridian. East and West lines end at 180 degrees, directly opposite the Prime Meridian.


Is there a fuse that runs to the purple wire to the starter in a 77 Chevy pickup?

Yes and it should be in your fuse block. Chances are that it is a relay fuse and you won't be able to tell if it is blown or not.

Related questions

Where is the fuel filter on a 1985 Fiero?

It is under neath the engine cradle and runs the same way as rear axle.


What temperature should a 2003 corvette run when it is 98 degrees outside?

My 03 runs up to 225 degrees,sometimes a little concerning.


Vacuum range 86 Pontiac fiero 2.8 v6?

A steady 20-25 at idle My freshly rebuilt 2.8 runs at 22.


What temperature should your car run at?

It will depend on the year, make and model but on older vehicles it runs on the average of 165 to 195 degrees and on the newer ones between 195 to 235 degrees.....


A refrigerant systems evaporator typically runs about how many degrees of superheat?

10 degrees


How many degress of longitude is the earth divided?

360 degrees. Longitude runs from 180 degrees East to -180 degrees West.


Which of these lines of longitude runs through the ural mountains 40 degrees east 60 degrees east or 80 degrees east?

60 degrees east longitude


What line runs through 23.5 degrees south and 23.5 degrees north?

The Tropics of Cancer and Capricorn


How do you know if the Intake gasket leaks on 1987 Pontiac fiero?

The engine runs fast, won't idle down, and many times the exhaust manifolds will glow red hot from the lean mixture.


86 fiero runs for 5 min then dies 2 hours later it will start and run for 5 mins then die again.?

A clogged fuel filter would be the most likely suspect.


Timing on a Chevy 350?

Depends on what year 350. It can be 2 degrees BTDC or 4 degrees BTDC. I would try 4 degrees and see how it runs.


When should i change the thermostat in Honda civic?

Usually you know it's time to change it when your car runs too hot because the thermostat is stuck closed. To test if a thermostat is bad check the following: Start to open between 169-176 degrees F(76-80 degrees C) Fully open at 194 degrees F (90 degrees C) Valve lift at fully open should be 8.0 (0.31) min.