It is very common for the battery to discharge on a vehicle sitting idle for 3 months. First disconnect the positive + & negative- battery cables, and clean the battery post and cable connections off. Apply a thin layer of dielectric grease or Vaseline to the battery post and connect the negative - cable. Put a battery charger on the battery and let it fully charge overnight. If it will not accept a charge it is defective. It it does show fully charged, connect the positive + cable and see if the engine will start. if not, then more than likely the battery is dead and needs replacing.
a door in your car is not fully shut.
Push the horn for five million hours
The most common reason for all of your dashboard cluster lights to go out is a blown fuse. Change the dashboard cluster light fuse.
The backup light switch and the brake switch are all in the same relay switch. The backup light switch can be found beneath the drivers side dashboard.
You replace the ignition cylinder and then turn the ignition (with key) to on position. All dash lights will light up in the on position. After a few seconds only the security light will flash. Leave the ignition on for 10 minutes while the security light flashes. At the end of the 10 minutes the security light will go out. This will be the first cycle of reseting the E.C.M. to read the new cylinder and ignition system replacement. At this point you do this process two more times. This will take proximately 30 minutes. At the end of all three cycles the car should come on. If you want someone to walk you through it E mail me at archuleta67@gmail.com.
No standing pilot, it is a spark ignition unit
ensure there is diesel in the car. Turn on ignition but don't start the engine yet. Watch dashboard and look for a small light (not ignition light) look for a heater plug light. When this goes off then turn ignition full turn and engine should start.
That is the maintenance required light. With the ignition off, push and hold the odometer reset button and then turn the ignition to the on position but do not start the engine. After a few seconds the light will go out.
It means the keys are still in the ignition. This light usually illuminates after you've opened a door.
Set your light switch to "auto" on the dash and your lights will come on automatically with the ignition. Turn your light switch on your dashboard to "auto" or "automatic" and the lights will come on and off with your ignition switch.
In order to reset the service light on a 2000 reg Megan you\'ll need to start by turning the ignition switch to the "On" position without starting the engine. Once the service light appears on the dashboard you can reset it by following these steps: Press and hold the odometer reset button Turn the ignition switch to the "Off" position Release the odometer reset button Turn the ignition switch back to the "On" positionAfter following these steps the service light should reset and no longer appear on the dashboard.
if the engine is running and the red srs light is on. it indicates that the airbag/bags are not working correctly. if the light is on then goes out when the ignition is on. they are functioning correctly
If it's the "change oil" light, turn the ignition to on, but don't start it, and tap the gas pedal 3 times.
Paradise by the Dashboard Light was created in 1976.
What kind of car? make, model, year?
i have renult megane cabrolete the car been standing for 10 months not been used the airbag light on why
I step on brakes, dashboard light comes on which says stop.