The size that fits your wheel nuts. -There are only 4 basic sizes, it can't be that difficult to figure out !
You must replace entire axle.
Open up the hood, and go in behind the fixture where the light is located. Sometimes there is an access panel on top. Open it and reach down inside and grab the bulb's socket. Twist the socket a quarter turn counter clockwise, and pull out the socket. Grab the bulb, and pull it straight out. To replace the new bulb, never touch it with your bare fingers, as this will greatly shorten the bulb's life, if it even work's at all. Use a tissue or something else in that order to handle the new bulb. Push the new bulb into the socket, put the socket back into the housing, and twist a quarter turn clockwise to secure the socket into the fixture.
i can do a full head and valves compleat in 8 hours.cleaning up before replacing takes time all must be clean,if you have a tension wrench then a novis should replace and tune the head and motor in 2 hours,make sure u bleed the water system well or u could crack the head bazmar
Only one. The filter is integrated into the fuel pump module, located inside the fuel tank. To replace the filter, you must replace the entire fuel pump module. To replace that module, you must first either remove the fuel tank or the truck box.
The entire dash assembly must be removed to gain access to the heater core.
Yoy put a 15mm wrench or socket on the belt tensioner and push down. Belt will slide off now. A belt routing diagram is a must.
Yes, you can . They must be mounted as a pair.
If it is all-wheel drive, then yes! HA! Drive tires must all be the same tread depth. Flatten one, replace 4. Oh, the downers of all-wheel drive!
Maybe: If the new wheel is the same size as the old then the old tires can be re-used. If you change the wheel size then yes they need changing
The spark plugs in a 2003 GMC Sonoma can be changed relatively easily with a socket wrench. However, the spare wheel must be removed from the wheel well to allow access.
you are not supposed to, depending on how many miles are on the rest of the tires they must all be replaced. In order to replace just one the new one must be within 1/32 to 3/32 of the other tires
You must get your tires changed every six years.
You must have small hands! You place your small hands behind the bulb socket and you turn the socket to the left until it becomes loose. Once loose, you pull out the light and remove it. Its very simple but must have small hands
You would need to have proper tools to do this. The tires must be removed and re-installed and the properly weighted. Most often, going to a trained professional would prove to be best and most efficient way of doing this.
No, it's possible in some areas to have your rims and tires be bought separately, but that all depends on where you go, and the availability of that service. It's easier to just replace them both at the same time.
you must either purchase the made together socket and bulbs from a authorized speedometer shop, and then take the instrument cluster out to replace the socket with bulb made together. or just pay the speedometer shop to do the job for you. just remove the band around the cluster and cup holder. then use a 7mm socket to remove 4 screws from the cluster and pull it out. turn it over and you can see the backside of the light sockets just twist and pull them out you must replace the whole socket and bulb together because they are made together.
You must first remove the radiator then remove the timing belt cover. Keep in mind you'll need a 10mm socket/ wrench and a 6mm hex driver along with screw drivers. Taking the fan and fan cluth off the water pump has helped me in the past. You don't have to be under the car for this, I did this from above only.