0
The knock sensor on the 1996 GMC Jimmy 4-wheel drive, 4.3 liter 6-cylinder is mounted in the engine block. Under the hood, look in the lower engine area on the passenger side, beneath the cylinder head.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you fix a knock sensor on a 1996 Mazda millenia?
It is a nonservicable part, just replace it.
Where location of a camshaft sensor GMC Sonoma 95 4.3 V6 Vortec?
The sensor is down on the front of the oil pan just behind the crankshaft pully, which is located at the front of the engine.
Where is the speed sensor located on a 91 geo prizm?
i have a 1996 Mazda protege and it is at the rear of the transmission if you're looking from the front drivers side. it is almost directly under the throttle position sensor which is located on the rear of your throttle body close to the firewall (almost directly in the center of the engine compartment).
What does a Vehicle speed control sensor look like for a 1996 Lincoln?
The VSS (Vehicle Speed Sensor) is located in the drivers side, back end (tail shaft housing) of the transmission. It is where they used to have the speedometer cable attached but now it's electronic.
Where is the starter on a 1996 gmc jimmy?
Look at the lower rear end of engine
Where is the knock sensor located on a 1996 Oldsmobile aurora?
Where is the Knock Sensor located on a 1996 Oldsmobile Aurora?
Where is the knock sensor located on a 1996 200SX?
The knock sensor for a 1996 200sx is located on the passenger side of the engine. It is located under the intake manifold.
Where is the knock sensor at on a 1996 cavalier?
The knock sensor is located on the side of the engine block near the bellhousing
1996 jimmy evap purge valve sensor where located?
where is the evap purge valve located in a 1996 jimmy
Where is the knock sensor located on a 1996 Toyota Avalon?
under the intake manifold
Where is the knock sensor located on a 1996 Crown Victoria?
It is located on the side of the engine block. If you have a code for a knock sensor and you have a noise in the engine, it will set the code. That does not mean that the sensor is bad. They very rarely give problems.
Where is the location of knock sensor 1996 Chevy S-10?
what part of motor is the knock sensor located on 1996 Chevy S-10 4 cyl. passenger side of engine block
Where is knock sensor located on 1996 GMC Sierra 1500?
The knock sensor is on the starter side of the engine. It is abut half way between front and back.
Where is the knock sensor on the 1996 Nissan Altima?
Knock sensorThe knock sensor for a 1996 Nissan Altima is located on the backside of the block above the oil filter.But before you go and change it out, run a tank of the best/hightest rated gas you can find and see if that fixes the problem. On my 1995 the Knock sensor is located under the plenum and intake manifold on top of the middle of the block.
Where is the knock sensor located on a 1996 Chevy Tahoe?
It is screewed into the side of the engine over by the starter.
Where is the knock sensor located on a 1996 Plymouth Voyager?
It is located on the engine block. A knock sensor will very seldom give a problem. It detects engine noises and retards to timing. If you have a code then you need to find the noise and repair it.
Where is the camshaft position sensor on a 1996 gmc jimmy?
It is located on the distributor under the cap and rotor.
