Take the car back to the dealer. Push in on the oddometer trip reset button, turn the ignition on, and hold the button until the display goes to 00.0.
If you mean the Flat tire indicator button, it's next to the parking brake.
RX350: With the car ignition off, press and hold the ODO Reset button and turn the ignition to the On position. Continue holding the ODO button depressed until the Maintenance Required light extinguishes, about 15 seconds.
Take the car to your nearest VW garage n get the thing serviced - If a service is needed! Otherwise: Note: the Service Reminder Indicator displays 3 messages: OEL, IN 01, and IN 02. These display to alert the driver to follow the items listed under the manufacturer's service interval. To reset the message displays, turn the ignition switch on. Press and hold the odometer reset button "A" located below the speedometer. Turn off the ignition while holding the button. "OEL" will display on the indicator. Press and hold the lower digital clock reset button "B" until five dashes appear in the display. If needed, press the odometer reset button until "IN 01" appears and then press the clock reset button until five dashes appear. If needed, press the odometer reset button until "IN 02" is displayed and then press the clock reset button until five dashes appear. To exit reset mode, turn the ignition switch on and when "IN 01" appears, turn the ignition switch off.
Usally U turn the key on without starting & pump the gas pedal 3 times with in 30 seconds. ??? I'm not sure about that answer. I usually press the button on the overhead computer where the service interval required shows zero, then hold the RESET button until it goes back to 3,000.
It just means it need an oil change and tune up. It does not monitor any engine systems and is only a reminder. Reset it at any time you please unless you actually use it as a reminder for maintenance. It also means that you have drivin your Honda for 5,000 miles :) I own a 1997 Honda Accord and my indicator light just turned RED but it was do to the fact that I slammed into someone and I guess the impact made the light come on but for the most part you can reset the indicator by putting your key in the slot next to the indicator if you have oneOr try to hold down the "Trip" button so it resets and this should work if it doesn't then get an oil change and a tune up and that should work :)
its on your rear end and armpit loser hair
There is none.
Owner's manual.
Where is the fuel pump inertia circuit breaker located on a 2008 Toyota Corolla
on my 2010 - push and hold the button
The little red button on the driver side is for overdrive.
It is on above of right vent the button is there on the top of middle vent console
its on the shift lever of my dx where your thumb hits the lever
The Flasher indicator relay is build build into the end of the Hazard warning button.
Turn the ignition key partially change display to "Trip A" and turn ignition OFF. Press the trip reset button and then turn the ignition key partially. Do not start engine. Hold reset button down until light goes off.
while the time is showing on the display, hold down the AM/FM button and press button 1 to advance the hours and button 2 to advance the minutes.
Look for a fuse on the left-panel below the driver. It controls the inside middle stop-brake light and the transmission button.