0
Why 1996 Sonoma not getting juice to the starter Everything else is working but when you turn the ignition switch it does nothing the dash lights don't even dim There's a disconnect somewhere?
Wiki User
∙ 14y ago
you ether have a broke wire in the steering coloumn or your key switch is no good, or you just may have a dirty wire at the battery or on your starter
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you remove the ignition from a 88 Acura Legend?
I recommend you getting a repair manual at your local automotive store.
1989 Mazda will not start it is getting fuel and has a good spark from the coil to the distributor cap but has a week spark at the plugs Have replaced ignition coil distributor pickup coil plug wires?
try to get a new ignition rotor
What would cause a car to crank but not start after turning off the engine yet the ignition coil seems hot?
Check to see if you are getting fuel.
Your 89 Geo spectrum wont start not getting any fire?
An ignition module problem could be the cause of your 89 Geo Spectrum not starting and not getting any fire. It could also be the pickup coil causing the problem.
How do you prevent getting staph?
wash your hands frequently and when in somewhere like a locker room be sure that you cover any wounds with band-aids.
Not getting electrical to ignition system of 1961 Ford Falcon?
I've replaced ignition switch, and starter solenoid, checked fuses, and battery, but I don't seem to be getting any electrical through to start the engine. I can jump everything and get the engine to turn over but not start.
When was Now We're Getting Somewhere created?
Now We're Getting Somewhere was created in 1986-09.
How do you describe traveling somewhere?
By getting in a car or plane to go somewhere
If you changed a motor from a 1993 Chevy S10 to a 1984 Chevy S10 and everything is working properly except the oil pressure gauge which pegs at 80 psi when the ignition is turned to run how do you find the problem?
Hey William==This means that the gauge on the dash isn't getting a signal from the sending unit. The sender is either not plugged in or there is a break in the wire somewhere. GoodluckJoe
How do you reset the computer on an 2002 Pontiac grand am after you have installed a new ignition switch?
When you install a new ignition switch, you should disconnect the battery. That will perform a computer code reset. If you are still getting codes, something is wrong. Check your wiring and make sure everything is properly connected and not shorted. Check the computer versus security system synchronization, particularly the key code sensor which is near the ignition switch. Make sure you did not break any of the conductors in the "clock spring" that connects the steering column with the rotating parts of the steering wheel. See the manufacturer's documentation for specifics.
When was Everything's Getting Older created?
Everything's Getting Older was created on 2001-04-26.
How do you change the heater core on a 1990 Buick Skylark I know it is on the drivers side but not exactly sure how to change it?
start under the dashboard and start getting everything out of the inside and then disconnect all the hosesand it should pop right out
Why is your ignition key getting hot?
You have a wire that is loose and arcing.
Why 305 motor is not getting sparks?
...could be allot of reasons why you may not be getting spark, here are some: # no power to ignition coil. faulty ignition. # faulty distributer cap, rotor. # faulty ignition module. # check for start signal from ecm. ...and there is a few more.
If there is no power to an hei coil on an 86 305 how would you go about getting power to it?
Check the ignition fuse also check the ignition switch
What are the release dates for Nick Nicky - 2012 Now We're Getting Somewhere?
Nick Nicky - 2012 Now We're Getting Somewhere was released on: USA: 24 February 2012
Your car is not getting a spark how do you fix that?
coil, wire, ignition control module
