0
Why is it that when my shift solenoid A is replaced that the check light still comes on after I reset the codes. I still have a problem with shifting from 1 to 2 and from 3 to 4 gmc 2000 siera?
Wiki User
∙ 17y ago
Not to be coarse, but that may have not been the problem or another was created during the repair or yet even still another problem existed and created the one you just fixed. If the ses light came back on, there will be code (s) stored. Get back on the horse and track them down. Troubleshooting can be very trying.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
The car has a strong battery power but does not start is it the starter?
it's easy to check the solenoid, put a screw driver across the large nut & the smaller one, and if the starter engages it's the solenoid .make sure the vehicle is in park, or the e- brake is on. ( with key on)
Car starts sometimes but sometimes it just clicks usually it will start after about ten tries what could be the problem?
start with checking the battery, next check the solenoid,next check the starter motor.then check ignition switch
Can anyone help Have ford f150 it will sometimes start and sometimes not if it starts it will sometimes just cut off have replaced starter and solenoid any ideas?
Check your fuel filter, this may be dirty.
Why wont explorer wont crank over. i have replaced the starter ignition solenoid and switch as well as the neutral switch but it still wont start or crank over when i turn the key. any solutions?
Check your ingnition cylinder ...
You replaced the starter and battery on a 1994 Ford Taurus but still just clicks and will not start any ideas?
You may have a loose or corroded ground connection. Not just the battery ground but the engine to chassis ground. You may also have a bad battery cable. If you see swelling on any part of the cable, replace it. Make sure the connections are clean and tight. Did you replace the starter solenoid with the starter, or is it a separate item? If the solenoid is separate from the starter, it is probably bad. It is unlikely that the ignition switch is bad, but possible.
Renault megane II check gearbox?
Common problem have Solenoid replaced Usually the pressure regulator valve.
Why did your 1992 Geo tracker 4 wd crank and then cut off and wont crank back?
crank sencer When I had the same problem it was the starter solenoid. It is built on the starter so you have to replace both. After the starter/solenoid was replaced I had no more problems. P.S. If you take it to most major auto parts places they can check the starter but not the solenoid mine showed good but after I replaced it I never had that problem again.
I have a 96 explorer with po756. I replaced the shift solenoid but did not fix. What else could be wrong?
If you replaced the correct shift solenoid (SS B), check for a broken band in the trans.
What might prevent a 97 Eagle Talon from shifting into gear after replacing the wiring harness and steering column?
If the trans. is an automatic, the prob. might be in the trans. shift interlock solenoid. This is a solenoid that prevents shifting into gear unless your foot is on the brake pedal. The solenoid is located on the steering column or under the center console on floor shift models. Check to see if you have any connectors unplugged at these locations, if you do, find where it goes and your problem may go away.
Why would a 95 Chevy camaro give problems shifting to 2nd gear the motor will wind out and you let off and put back on gas and it changes?
Check the shift solenoid on the side of the 95 Camaro transmission. Also check for any vacuum leaks. You most likely have a problem with one of these.
Renault megane 1.6 auto 2nd gear jumps?
Check the solenoid. This happened to us and we had to have the solenoid replaced. Part cost about AUD$240 but labour was $800!
After replaced transducer of EGR but the check light still on what should you will replace next?
try the solenoid controlling the egr
Can a broken engine oil dipstick cause hard shifting?
a broken dip stick wont cause hard shifting... the engine does not do the any shifting... your problem would be the transmission... check transmission....
1990 ford f250 will not charge you have replaced the alternator voltage regulator and batteries What could be the problem?
You have a wiring problem. Check really close the small wire on the solenoid. This wire is located on the opposite side of the solenoid that the big wire going to the starter is on. These are usually found corroded and/or broken inside the jacket insulation. You can run a jumper wire to test or use a tester.
1994 Honda Accord EX with 175000 miles on it It leaks oil either at the VTEC solenoid itself or right below the solenoid you replaced the gasket on the solenoid but it still leaks?
You should also check the plug on the engine's front balance shaft. This location often causes trouble on the 94' model Accords. If there is no problem there then check the oil pan itself do to a possible rubber gasket dry rotting or failing weld/ seams.
How do you check the solenoid wire harness to the transmission of 1999 Chevy silverado?
The first and largest problem is access to the wire harness on the solenoid. This is an issue you shouldn't attempt yourself, and is better completed at the dealership. There, they will use an electronic device to check different points in the solenoid.
You get a click when you try to start your 1985 Chrysler The battery is good and it will start right up when you get under the car and jump the solonoid connections with a screwdriver Is the solenoid?
solenoid is bad ,have it replaced,but check for remote solenoid first some vehicles have another solenoid mounted closer to battery
