It is located on the rear passenger side of the motor below and behind the exhaust manifold. It is easier to get to by removing the passenger side wheel and inner fender trim.
The Crankshaft Position Sensor senses it's position from a toothed timing ring behind the Crankshaft pulley. The CKP is above and to the left of the crankshaft pulley.
It does not have one...everything is in the distributor except for the amplifier module which mounts on the fender well.
Crankshaft position sensor circuit malfunction.
Modified resection
The crankshaft sensor on a 2 door Honda Accord with a 3L V6 engine is located on the side of the engine, near the oil filter. It screws into the side of the block and outputs the loading of the crankshaft to the vehicle's computer.
it is located on the side of the transmission
The crankshaft position sensor mounts to the top rear of the transmission bell housing.
front of transmission.
The crankshaft position sensor is on the driver side top of the transmission bell housing.
The crankshaft sensor on a 1999 Chevy Blazer is located on the bottom of the engine, near the oil filter. It connects to the vehicle's computer and constantly updates it on the crankshaft's position.
The crankshaft position sensor is mounted in the transmission bellhousing at the left/rear side of the engine block
The crankshaft position sensor is on the top driver side of the transmission bell housing.
The crankshaft position sensor is at the rear of the engine where it joins with the transmission bellhousing. It is at the left (front) side, not far from the starter.
The crankshaft position sensor is at the rear of the engine where it joins with the transmission bellhousing. It is at the left (front) side, not far from the starter.
The crankshaft position is on top of the transmission bell housing on the drivers side. The sensor can be replaced by unbolting and unhooking the plug.
The Crankshaft Position Sensor (CKP) is mounted on the top of the transmission bell housing. Assuming you are talking about the 3.3L V6.
The crankshaft position sensor on a 3.5L Chrysler Pacifica is located next to the motor, toward the rear. It can be found next to the transmission.