there should be 2 trim peices on the dash u can pop out with a flat head each trim has 1 screw under it remove the screws if its a automatic turn the ignition on but dont start the truck move the shifter all the way down (1st) or (low) then pull the dash off unplug any wireing harnesses hooked in to the dash (headlight, fuel swich, ect.)
The headlight is just a bulb. Open the hood and look at the inside of the head light cover. There is a knurled ring that twists and pulls into the engine compartment.
The bulb should pull out with the wires and detach from the bulb. (you may have to rock it lightly up and down as you pull on it it has a rubber o-ring)
Installation is the reverse.
Be very sure that you don't handle the bulb with your bare hands. The oil on your hands can get hot enough to bubble the headlight bulbs. Use a cloth or gloves to install the new bulbs.
dimmer switch is on the turn signal lever, to replace you need to remove steering wheel
very simple remove 2 screws holding housing around lever, then u can access switch without any problem i think only remove 2 taps. i worked on my 99 ranger this should be same. bobby russell springs, ky
Remove the door panel. Remove the switch retainer. Remove the wiring harness. Reverse the process to install the new switch.
Prior to do any work on your 1967 Ford Mustang, you must disconnect the battery ground cable from the battery. Next, remove the two screws and lower the parking break and air control. In order to remove the control knob and shaft assembly, place the know in the full ON position. You will now be able to press the knob release buttom on the switch assembly.
POSSIBLY A LOOSE GROUND WIRE AT LEAST THAT IS WHAT I AM LOOKING FOR ON MINE,GOOD LUCK! The most likely cause on the late 80's Bronco & Ranger for headlight problems is the failure of the Dimmer switch connection. I had to completely replace the connector & switch on my '88 Bronco II to resolve the problem.
Remove the knobs, remove the dash panel, and replace the switch.
there is a pin on the switch which must be depressed to remove the unit from the dash.
How to replace a clutch interlock switch on a 1997 Ford Ranger XLT
Disconnect the negative cable. Remove any screw from the switch. Slide the switch from the dash. Remove the switch and insert the new switch.
To replace the headlight dimmer switch on an 87 Olds Delta 88 you need to open the instrument panel under the steering column. Next, remove the two screws holding the switch in place, remove old switch, and reverse directions to replace with new switch.
In order to remove the headlight switch of a 1988 Cadillac Eldorado, you must first disconnect the negative cable from the battery and allow time for the capacitors to discharge. Unscrew the headlight switch, remove the wire plugs, and remove the switch itself. Insert a new switch and replace the wire plugs and screws. Reconnect the negative cable and test the new switch.
The headlight dimmer switch is located on the end of the lever. Remove the steering column so the lever can be properly reached.
how do you replace the headlight switch on a 1993 cutlas ceria*
First you have to disconnect the battery.The you will need to remove the know off of the headlight switch on your Suburban. After that you will need to remove the bezel on the dash board so that you can access the switch. I've also included a video that shows this whole procedure.
I need to know how to install a headlight swith in a 1991 ford ranger xlt
To replace the headlight switch, disconnect the negative battery cable and wait 10 minutes. Next, remove the screws around the switch. If there are no screws, pry the holding ring that keeps the switch in place away from the dashboard. Slowly slide out the switch and disconnect the wire plugs. With the switch in the 'on' position, push on the headlight case button and remove the switch. There may be a nut that needs to be removed. Slide the new switch into the housing. Replace the nut if you had to remove one. Carefully reattach the wire plugs. Slide the housing back into the dashboard. If you had to remove any screws from the dash, replace them. Test the lights to make sure they're working and then reconnect your battery cable.Ê
dimmer switch is on the turn signal lever, to replace you need to remove steering wheel