I have a 94 Nissan Sentra but it's the same body style. My starter is located right below all the air intake hoses. the easiest way to find the starter is to take the airbox stuff out and then follow the ground wire from the negative end of the battery (the only wire leading off the negative end) to where it attatches to the transmission. The bolt that that wire attatches to is one of two bolts that attatches the starter to the transmission.
how do you remove a distributor rotor on a 92 Nissan sentra
The starter on a 92 Buick LeSabre is replaced by disconnecting the battery, removing the retaining bolts, and lowering the starter. The wiring harness can then be disconnected and a new starter installed.
with great skill and dificulty
I have a 92 with a 1.6 and get about 34 miles per gallon.(SMILE)
right next to the tranny, it has a red and black wire on it
I dont have the answer, but my 92 does the same thing
remove bolts and replace it how do u think
The starter is located on the right hand side of the bell housing under neath the motor
bottom of engine, passenger side. where the engine meets the transmission.
The alternator on a 92 Nissan Maxima is changed by disconnecting the wiring harness, loosening the retaining bolts, and removing the drive belt. The bolts can then be fully removed and the alternator swapped out.
You take the bolts out of it.... replace with new starter and put the bolts back in Although Chiltons shows the removal of the starter from the car, I can't find the location of the starter under the hood. I think it's quite a distance from the battery, but I'm unsure. Can someone help me - I'm a beginner. Also, Chiltons refers to labeling the wires before removing the starter.... Is a wire directly connected to the battery from the starter? If yes, is it the positive or negative wire. The starter for a 92 Nissan sentra is located above the oil filter. It is not hard to change out. Remove the air filter assbly. Reach down under the air intake mess and remove the first bolt 14mm. Secondly locate a big wire (yellow and black) on the front of the transaxle with a bolt going thru it. Remove that bolt. It goes through the cowling and screws into the top hole on the starter. Swing the starter up and turn and remove wire. 13 mm bolt. Reverse process to install. I used a Beck Arnley rebuilt part number 187-0387.
Go to your auto parts store and get a Chilton or Haynes repair manual for your vehicle.