at the base of the wiper arm is plastic it looks metal but it isn't remove it with a flat head screw driver then use a 1/2" wrench or sockett to remove the nut and the arm will come off at the base of the wiper arm is plastic it looks metal but it isn't remove it with a flat head screw driver then use a 1/2" wrench or sockett to remove the nut and the arm will come off
Remove the wiper arm retaining clip. The retaining clip will be just below the wiper arm connection. Hold the retaining clip in and the wiper arm will come off.
Disconnect battery negative, Remove airflow meter and pipe, Disconnect clutch cable and remove clutch arm from gearbox (mind as clutch arm spacer falls out) Remove starter feed and trigger, Remove the three hex headed bolts that hold in starter, Remove starter, it will come out from the bottom and you may need to twist and turn it but trust me it does come out. Refit in reverse order You do not have to remove the clutch cable or arm, but for the rest the info above is correct.
remove everything in order to get the arm ready to come off,remove tire, calpier assy, shock, sway bar, knock lower arm loose loose from spindle, vehicle jacked up of course, lower arm ,remove two bolts where control arm is mounted to frame, hammer and cold chicel to remove bushings, revser of it put back all you have taken loose.
Take out the shock. It unbolted at the ends. Remove the cotter pin and then the bolt from the upper control arm bearing. Use a pickle fork to separate it from the wheel. Remove the nuts on either end of the arm from inside the engine compartment. Tap the bolts through an remove from the wheel well side. A-arm should come out with maybe some help from a rubber mallet.
Drain the water from your Corvette radiator. Remove the radiator hoses. Remove the radiator stabilizing arm bolt. Remove the radiator retaining bolts. The radiator will come off.
remove the top of the caravan so that it can easily come out of it
You can remove the sun visor on your Toyota Rav4 by removing the screws on the swivel arm. When they screws are remove the visor should come off.
On most cars its possible to remove the lower control arm without removing the axle nut. however sometimes the nut on the ball joint stud wont come off because the axle is in the way. If that happens try loosening the nut as far as you can then pop the ball joint loose. When it drops it will allow you to finish removing the nut. Good luck Tomtv
don't know,why am i not getting an answer.
Scrub it with arm water then wash. It may take a wash or two, but it will eventually come out.
You first need to remove the fore arm and then the barrel needs to be removed from the receiver. The bolt will then come out the front of the receiver.