Remove the two headlight mounting bolts and slide the entire headlight assembly forward. You can then disconnect the Bulb from the sockect and remove the bulb from the headlight housing. Installing is just as easy. Install the new bulb, connect the blulbs electrical connection and re-install the headlight. Should take about 5 minutes all togather.
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.
To replace the license plate light bulb on a 2001 Oldsmobile Aurora, first, open the trunk and locate the license plate light assembly. Use a flathead screwdriver to gently pry off the lens cover. Remove the old bulb by twisting it counterclockwise, then insert the new bulb and twist it clockwise to secure it. Finally, snap the lens cover back into place and close the trunk.
In an Oldsmobile Aurora, the fuse for the license plate light is typically located in the fuse box, which is usually found under the dashboard on the driver's side or in the engine compartment. Refer to the owner's manual for the exact location and designation of the fuse, as it may vary by model year. If the license plate light is not functioning, check the fuse for continuity and replace it if necessary.
how do you replace license pate light on 2006 pontia g6
Unscrew license plate and remove to expose light fixtures. Wedge light module away from holes. Replace them and return them to sockets.
How do you change the liscence plate light fuse
Same circuit/fuse as the parking/tail lights.
To replace the license plate light bulb on a 2008 Hyundai Accent, first, locate the license plate light assembly at the rear of the vehicle. Use a flathead screwdriver to gently pry off the light cover. Remove the old bulb by twisting it counterclockwise and replace it with a new bulb by twisting it clockwise until secure. Finally, reattach the cover and ensure the light functions properly.
To replace the license plate light bulb on a 2006 Honda Pilot, first, locate the light assembly above the license plate. Use a flathead screwdriver or a similar tool to gently pry open the light cover. Once the cover is removed, twist the old bulb counterclockwise to remove it and replace it with a new bulb, ensuring it is securely in place. Finally, reattach the light cover and check that the light is functioning properly.
Remove the screws from the lens covering the bulb, pull out the bulb and replace it.
Superdiscount LEDs has a tutorial out how to change the license plate light to an LED light. Its pretty general how to do but a lot easier with pictures. Heres to step by step links that should help you! http://www.superdiscountleds-how-to-install-leds.webs.com/ -OR- http://www.go-audi.com/14083-audi-q5-how-do-i-replace-license-plate-bulbs.html Source: www.superdiscountleds.com
there are two spots above the license plate where the lights go on each one there should be a spot where you can push the cover in and then just pull out at an angle