0
What else can I help you with?
What are the best installation tips for using tileboard on bathroom walls?
When installing tileboard on bathroom walls, it is important to properly prepare the surface by cleaning and smoothing it before applying adhesive. Make sure to measure and cut the tileboard accurately to fit the space, and use a level to ensure it is installed straight. Apply adhesive evenly and press the tileboard firmly into place, using spacers to maintain even spacing between tiles. Seal the edges and seams with caulk to prevent water damage.
What are the common sizes for paneling and tileboard?
As I know in the USA ,It's sold in 2400 x 1200 sheets for about US$10 a sheet currently (2010). more info you can visit www.globalwoodplywood.com to get the details and the mills who can produce this type of panel tileboard located in china.Peter HAN peterhan@vip.163.com
Should you say Attached are the reports or Attached is the reports?
attached are the reports
How should tileboard be attached to a stud wall?
If you are referring to panels that look like ceramic tile, I would not attach this directly to studs as it is too thin and flexible. It should have more support than what studs on 16" centers can provide. Use a tile board adhesive to apply the board over primer finished drywall. If this is concrete board used as a substrate for tile, use cement board screws. They have a fluted end that acts as a drill bit to cut through the board, making it easier to penetrate.
What should be attached to the primary Y port in an IV set up?
Piggyback IV should be attached there.
When connecting a battery, should the red or black wire be attached first?
When connecting a battery, the red wire should be attached first.
Should you have preschools attached to mainstream schools or should they be independent?
they should be independent
During electroplating the item to be plated?
The item to be plated should be attached to the negative terminal of the battery.
How to tighten serpentine belt on subaru?
There should be a bolt attached to the alternator that should work.
When changing a car stereo should ALL the wires from the car stereo connector be attached to the radios wires or vice versa?
They all should be attached to a wiring harness un less your install a radio then not all wires will be attached to the after market harness in most cases the wires that are not attached can be used to hook up subwoofers
What side of the LED should the resistor be attached to?
It doesn't mater.
You like this guy but he has stings what should u do?
what are the strings attached
