This greatly depends on make and model... but most vehicles have two hinges on the inside of the door... usually four bolts your have to take off with an extension and a ratchet. if you have power accesories you need to feed those wires back through the door wire boot... and also there is usually a stop pin that you have to remove in the middle of the 2 hinges which keep your door from opening too far...
Gas-axe.
smash the door off
open the door then drive into it with another car and it should remove it safely if not just use a hammer
Burn the car !
The best way to do that is open the door borrow another car, and drive into it its the fastest way to remove the door, then the rest is simple
All you can do is to remove the door panel and flick the catch manually, You may have to remove the seat to enable you to do this.
Depending on the year, but i have a 95 and there are screws going around the outside ov the door panel remove those
You have to:Remove the door panel.Undo the rods off of the handle.unbolt the door handle from the inside of the door.
Can you get inside the car and remove the interior panel of the door that is stuck ? If you can remove that panel you will be able to manually pull the door catch (And then open the door and have the door latch fixed properly)
You nedd to do a restting of the openers to the garage door. just don't include the car.
To remove the rear seat from a 1989 Ford Laser 4 door car, first remove the bolts anchoring the rear seat to the floor of the vehicle. Then, lift the bottom portion of the seat from the car. Then, remove the internal bolts from the hatchback or trunk of the car to remove the seat back.
Remove the door panel, find and repair the lock linkgage.