tricky ? my 4 door did and it was a 90 model gs but my 93 2 door ls didnt so just pull 1 out and look at the end there should b a raised almost grae looking thing right where the axel meets up w the hub other way is look at the hub if it has abs there should b a harness that follows the strut all the way to the hub
Only the GS and GS-R did in 1990, not the base model.
-r0mp Mike
Yes that year integra is equiped with ABS
Yes that year integra is equiped with ABS
No, it does not have ABS front or rear.
In a 1992 Acura Integra, the ABS fuse is located in the under-hood fuse box. This fuse box is typically situated near the battery on the driver's side of the engine compartment. To locate the specific ABS fuse, refer to the diagram on the fuse box cover, which indicates the position and amperage of each fuse. If you're experiencing issues with the ABS, checking this fuse is a good first step.
you may have air in the brake line. bleed all the brakes. if the light still comes on intermittently go next to bleeding the line at the master cylinder.
you need a special tool called a t wrench
Factory ABS has certain time to be serviceable. Once it's past due, when the abs lit comes up, it needs to be brought to servicing department to check for integrity. The reason for ABS light on is the ABS system is bad. The most common issue of Honda/Acura ABS is the Nitrogen tank lost the pressure. The solution is to replace the whole unit (Not computer control).
The ABS light in your 1996 Acura Integra indicates a problem with the Anti-lock Braking System. This could be due to a faulty ABS sensor, a malfunction in the ABS module, or issues with the brake system itself. When the light is illuminated, it’s essential to have the system diagnosed to ensure your brakes function properly and to maintain safety while driving. Ignoring the light can lead to reduced braking performance, especially in slippery conditions.
A 2002 Honda RSX ABS modulator is not directly compatible with a 1996 Acura Integra due to differences in design and electronic systems. The ABS systems in these two models were developed for different generations of vehicles, and the wiring, mounting points, and hydraulic connections may differ. If you're considering such a swap, extensive modifications and wiring adaptations would likely be necessary, making it impractical. It's advisable to seek a modulator specifically designed for the 1996 Integra for optimal performance and safety.
if the ABS light is on on the dash, it is disabled and not working. to reset, pull the backup/radio fuse under hood for at least 20sec (**caution-this will reset all the onboard computers and there may be drivability issues until the computers have relearned.). if there is a hard fault though, it'll come right back on and disable the ABS system. repairs will have to be made before that changes.
The brake light on a 2000 Acura Integra may be illuminated due to several reasons, including a malfunctioning brake light switch, low brake fluid levels, or a blown fuse. Additionally, it could indicate an issue with the anti-lock braking system (ABS) or worn brake pads. It's important to inspect these components to diagnose the exact cause and ensure safe operation of the vehicle.
Make sure it isn't the tire causing the noise first- and then- You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.