In a 1992 Acura Integra, the ABS fuse is located in the under-hood fuse box. This fuse box is typically situated near the battery on the driver's side of the engine compartment. To locate the specific ABS fuse, refer to the diagram on the fuse box cover, which indicates the position and amperage of each fuse. If you're experiencing issues with the ABS, checking this fuse is a good first step.
No, it does not have ABS front or rear.
Yes that year integra is equiped with ABS
Yes that year integra is equiped with ABS
Make sure it isn't the tire causing the noise first- and then- You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
The brake light on a 2000 Acura Integra may be illuminated due to several reasons, including a malfunctioning brake light switch, low brake fluid levels, or a blown fuse. Additionally, it could indicate an issue with the anti-lock braking system (ABS) or worn brake pads. It's important to inspect these components to diagnose the exact cause and ensure safe operation of the vehicle.
Factory ABS has certain time to be serviceable. Once it's past due, when the abs lit comes up, it needs to be brought to servicing department to check for integrity. The reason for ABS light on is the ABS system is bad. The most common issue of Honda/Acura ABS is the Nitrogen tank lost the pressure. The solution is to replace the whole unit (Not computer control).
remove the fuse or relay is the easyest way but the abs light will be illumeinated very annoying.
if the ABS light is on on the dash, it is disabled and not working. to reset, pull the backup/radio fuse under hood for at least 20sec (**caution-this will reset all the onboard computers and there may be drivability issues until the computers have relearned.). if there is a hard fault though, it'll come right back on and disable the ABS system. repairs will have to be made before that changes.
In a 1992 Volvo 940, the ABS fuse is located in the fuse box under the dashboard on the driver's side. You can find the fuse box by removing the cover, and the ABS fuse is typically labeled in the diagram on the inside of the cover. It is usually a 15A fuse, but always check the owner's manual for the specific fuse number and rating. If you're having issues with the ABS system, it's a good idea to inspect this fuse first.
The ABS light in your 1996 Acura Integra indicates a problem with the Anti-lock Braking System. This could be due to a faulty ABS sensor, a malfunction in the ABS module, or issues with the brake system itself. When the light is illuminated, it’s essential to have the system diagnosed to ensure your brakes function properly and to maintain safety while driving. Ignoring the light can lead to reduced braking performance, especially in slippery conditions.
It is a 20 amp fuse in the under the hood fuse box, I think it is the same as the Mass air flow, and transmission fuse.
I also need 1 of the fuse box diagram. not the 1 under the steer column. but the on by the battery. ( mind is missing the diagram ) so i dont know what fuse belong where, let me know if anyone got 1. i have the 3rd fuse box diagram for the ABS relay which is by your fuel injection let me know if anyone of you need. that fuse box is under your engine and is approx. 2 1/2 inches x 6 1/2 inches.