To adjust the sensitivity of the anti-theft system in a 2005 Mazda RX-8, you typically need to access the vehicle's keyless entry system settings. Using the key fob, press and hold the unlock button while turning the ignition to the "On" position and then back to "Off." This process may vary slightly, so consult the owner's manual for specific instructions or settings related to the anti-theft system. If you're unsure, it's best to visit a Mazda dealership for assistance.
YOu need to blead the system .. then it should require no adjusting
1) Just start your car with the coded key 2) Pull the battery cable but do not leave it off too long only a few short seconds. (if you leave it off too long the pcm will forget the saved key code then you will need your pcm flashed in order to work with your key again) 3)Bypass the antithief by removing the antitheft wirers. The antitheft system only cuts power to the starter. run your own wiring to the ignition switch to bypass the antitheft.
The majority of time if you adjust the rear brakes it will adjust the park brake.
How do I adjust a stoplight switch on my mazda 626 LX V6
this sounds fishy .... Did you screw that motor up ?
The 1992 Mazda Miata is equipped with a non-adjustable steering wheel.
there is a small long bolt on the left side of the brake handle tighten the nut to adjust
on top of the upper intake there is a screw. it can be used to adjust idle speed.
Also,do you adjust them warm or cold?
It should have disk brakes on the rear, no need to adjust. If you need to adjust the E-brake do it from the handle in the car (would need to remove trim to get to cable)
B2600 has a carburetor system and B2600i has an injection system.
Hi, the gao for a mazda B2600 is 1.0 + o - .1 So it could be 0.9 1.0 or 1.1 just adjust it the best