To remove a starter motor from a Hyundai Excel, first disconnect the negative battery terminal to ensure safety. Next, locate the starter motor, which is typically mounted on the engine block near the transmission. Remove the electrical connections and unbolt the starter from its mounting, usually secured by a couple of bolts. Carefully pull the starter out, ensuring you don't damage surrounding components.
In a 1995 Hyundai Excel, the starter motor is located on the lower side of the engine, near the transmission. It is typically mounted to the engine block, close to the flywheel. To access it, you may need to raise the vehicle and remove any obstructing components. Always ensure the battery is disconnected before attempting to service the starter motor.
The Starter motor on a fuel injection Hyundai Pony/Excel is located below the inlet manifold coming from the injection system. It is difficult to access and the only way to get there is by removing the actual inlet manifold.
# Disconnect the negative battery cable # Remove the air intake duct and the air cleaner assembly # Disconnect the speedometer cable from the transaxle # Unscrew the nut and disconnect the battery cable from the starter motor then disconnect the wiring from the solenoid # Remove the starter motor mounting bolts,supporting the starter motor as the bolts are removed and remove the starter motor
# Disconnect the negative battery cable # Remove the air intake duct and the air cleaner assembly # Disconnect the speedometer cable from the transaxle # Unscrew the nut and disconnect the battery cable from the starter motor then disconnect the wiring from the solenoid # Remove the starter motor mounting bolts,supporting the starter motor as the bolts are removed and remove the starter motor
I can't say were because I'm yet to look but if you follow the positive terminal it should lead you there.
how to change starter on Hyundai scoupe 1993 12 valve
how do i remove the starter motor Mazda rx8
It can be found at the back of the engine about half way down the block, you will need to jack the car up to get to it, if you need to change it out. hope this helps.
Disconnect the cable from negative terminal of the batteryIf working on a 2.0L detach the shift cable from the transaxleDisconnect the speedometer cable from the transaxleUnscrew the nut and disconnect the battery cable from the starter motor then disconnect the wiring from the solenoidRemove the start motor mounting bolts and remove the starter
how to remove starter motor on bmw 745
how to remove starter motor for Peugeot 206 1.4 hdi.
How do i remove an Audi A6 Starter motor