0
If it's the V6 (can't answer for the 4), it's not easy, a lot of the engine accessory area has to be disassembled for this and valve cover removed (requiring new valve gaskets which are probably leaking anyhow), etc. Anything regarding timing belt (or water pump), and front wheel bearings, I consider "non-user serviceable", it's something for Mazda or a reputable Mazda certified repair department to handle. For the timing belt, simply go to Mazda, tell them you need your 60,000 mile (or equivalent multiple) service performed, get your wallet out to the tune of $840 or so USA dollars, and have alternate transport for a couple of days. This will get a lot of stuff cleaned and checked up, if you buy the parts separately, including replacement gaskets (valve cover (front required, both should be done though since you are in there), timing cover gasket, etc, you'll end up spending more for the parts than Mazda does for the overhaul, trust me on that.
What else can I help you with?
How do you set timing on a 1995 Mazda MX3?
This is done the same as the 1995 Mazda MX6. The answer is posted.
How do you replace fan belt on 1994 Mazda mx3?
well...there is no fan belt on any model of mx3, its using an electrical fan, and if you have A/C it has a second electrical fan just beside it. If its not working, it could be the relay, the motor, or the coolant sensor
94 Mazda mx3 1.8 timing belt replacement diagram?
To replace the timing belt on a 1994 Mazda MX-3 1.8, you'll need to refer to a service manual for a detailed diagram, as it provides the specific routing of the belt. Generally, the process involves removing the protective covers, aligning the timing marks on the crankshaft and camshaft, and then installing the new timing belt while ensuring proper tension. It's crucial to follow the manufacturer's specifications for torque settings and belt tension to ensure proper operation. Always double-check the alignment before reassembling the components.
How to replace a fuel filter on the 1994 Mazda mx3?
its on the fire wall
When to change the timing belt on a Mazda mx3?
The timing belt on the b6 & k8 motors should be changed every 60-80k miles depending on the wear of the belt. You can check the wear yourself by removing the valve cover on the b6 model where as the k8 is somewhat more difficult and will require removing the timing cover. If there are any nicks, frays, or cracks the belt should be replaced.
How do you change your water pump on a 93 Mazda mx3 4cylinder?
To change the water pump on a 1993 Mazda MX-3 with a 4-cylinder engine, first, disconnect the negative battery terminal and drain the coolant. Remove the drive belts, then take off the timing cover and loosen the timing belt tensioner to remove the timing belt. With the timing belt out of the way, unbolt the old water pump, clean the mating surfaces, and install the new pump with a new gasket. Reassemble in reverse order, ensuring proper alignment of the timing belt and tensioner.
How do you loosen the alternator belt on a Mazda Mx3?
On a Mazda MX-3 (1994) you need to tighten the adjustment bolt that is close to the fire wall. Tightening the bolt loosen the belt - loosening the bolt tightens the belt
How much would it cost to replace a timing belt on a Precidia?
it cost me $600 (Canadian dollars) at a mechanic for my v6 mx3. the engine is an interference design so the valves will be mashed by the pistons if the timing belt breaks so it's worth doing if you want the car for a while.
How do you change the serpentine belt on a 1995 Mazda mx3?
on the alternator on top is a bolt losen that bolt and it will allow you to move alternator causing belt to losin
Head gasket bolt torque specs for a Mazda mx3?
What are the head bolt torque specs for a mazda mx3 1600
When was the Mazda MX3 first produced?
The Mazda MX3 was first produced in 1991. It was introduced at the Geneva Motor Show in March of 1991. The MX3 was produced until 1998, when production was halted.
Mazda mx3 gets no fire changed fuel pump distributor pcm timing belt crank sensor what is left?
try HEI mod it should work http://www.mx-3.com/phpBB3/viewtopic.php?f=15&p=461052
