0
The O2 sensor heater fuse on a 2002 Subaru Legacy is typically located in the engine compartment fuse box. To access it, open the fuse box cover and look for the fuse labeled "O2 Heater" or similar. If unsure, refer to the fuse box diagram, which is usually found on the inside of the cover for specific fuse locations.
What else can I help you with?
Where is the speed sensor on a 91 subaru legacy?
In a 1991 Subaru Legacy, the speed sensors can be found on the driver's side of the transmission. They are located towards the rear, and there are three of them.
Where is the Knock Sensor located in a 2000 Subaru Outback Legacy?
It is located on the engine block drivers side.
Where is the knock sensor location on a 1998 subaru legacy?
In a 1998 Subaru Legacy, the knock sensor is located on the top of the engine block and to the left of the engine. More specifically, it is under the left rear intake manifold runner.
Where is the fuel pressure sensor located on a 1998 Subaru Legacy station wagon?
on top of the fuel tank
Where is the oxygen sensor located on your 1997 subaru legacy?
Both o2 sensors are located on catalytic converter. Sensor closest to front of car is upstream sensor. Sensor closest to rr of car is downstream sensor.
Where is the fuel filter located on a 2006 Subaru Legacy?
Where is the fuel filter located on a 2006 Subaru Legacy
What is the wiring on map sensor for 2000 subaru legacy?
The wiring map sensor tells the diagnostic program. If the problem arises and where the problem is located. The wiring map sensor is located below the dashboard.
Where the coolant temperature sensor located in 1996 subaru legacy outback?
http://www.lovehorsepower.com/SubaruDocs/CoolantTempSensor.htmlits a 1995 but same thing
How many wires on a after cat O2 sensor subaru legacy?
four4
Where is the map sensor on a 1996 Subaru legacy?
It is located to the right of the ignition coil pack, on top of the motor. It is the black sensor, right behind the alternator, bolted into the intake manifold.
Where is the rear demister on a Subaru legacy?
The rear defroster (demister) on a Subaru Legacy is built into the window. The lines going across the back window are actually the defrosters. If the vehicle is equipped with a rear wiper, the switch for this should be located below the radio and heater controls.
Where is the IAT sensor on a 1995 Subaru Legacy?
The IAT is located in the air intake duct. First, find the intake air hose, and then follow that to the sensor, which should be located with the mass air flow sensor if it is double?æoverhead cam engine.
