The engine turns off when the oil cap is removed because the engine is designed to do so. When the oil cap is removed a vacuum leak is created which causes the engine to turn off.
To open the engine oil cap on a 2001 Ford Mondeo, first ensure the engine is cool and the vehicle is parked on a level surface. Locate the oil cap, which is typically found on top of the engine, marked with an oil can symbol. Twist the cap counterclockwise to unscrew it, and lift it off. Be cautious not to drop debris into the engine while the cap is removed.
Take the distributor cap off and turn the engine. If the rotor turns it's not "stuck".
There is a cap that turns about 1/4 turn to be removed on top of the P/S reservoir, which is attached to the P/S pump. Take it off and add fluid until it reaches the mark on the stick, which is part of the lid.
no
1.) WITH THE ENGINE OFF! and the ENGINE COLD! -take the radiator cap off and see if you can see water (or coolant) inside. If not, add enough water or coolant until it you can see it. Put the cap back on securely.2.) WITH THE ENGINE OFF! and the ENGINE COLD!-Check to see if the belt that runs over the pulley that turns the fan behind the radiator is tight. It should push in about an inch by just pushing it with your finger. If not, tighten it or have a mechanic do it for you.3.) WITH THE ENGINE OFF!-Check to make sure you have enough engine oil in the engine.
The oil filter on the 2007 Pontiac G5 is located under the plastic Eccotec top engine shroud, this is removed first by removing the oil add cap, then pull up on the corners of the cover, after it is removed location of the oil filter can be spotted by locating the engine dip stick and then looking towards the engine block there you will see a black cover cap approximately 3 inches in diameter with a hex head mount for loosening the cap for complete removal. The filter is attached the the cap as it is removed, pull off the old filter replace with new and reinstall. The oil filter itself is accessable from the top of the engine.
The Oil Filter is on the top of the engine, to the left of the valve cover. It has a plastic cap that can be wrenched off. The Oil Filter is not a sealed filter that you are used to seeing. It drops in where you removed the black cap.
To remove the oil cap from a Peugeot 307, first ensure the engine is cool for safety. Locate the oil cap, which is usually on the top of the engine, often marked with an oil can symbol. Grip the cap firmly and turn it counterclockwise until it loosens and can be removed. If it's stuck, try using a cloth for better grip or gently tap around the cap to break any seal.
To change the distributor cap on a 1996 Mitsubishi Mirage, first, ensure the engine is off and the keys are removed. Disconnect the negative battery cable, then remove the screws or clips securing the distributor cap, and carefully lift it off. Before replacing it, note the position of the wires and their order, then transfer the wires to the new cap, and secure it in place. Finally, reconnect the battery cable and start the engine to ensure proper operation.
The oil FILLER cap is turned about a quarter ( 1/4 ) turn to the left and lifted out.The oil filter is removed by using a special tool to unscrew it from the engine block.
take off the distributor cap and have someone turn the engine over to see which way it turns. NEW ANSWER: CLOCKWISE rotation
With the distributor cap off have some one turn the engine over. If the rotor doesn't turn you broke the cam or a timing gear.