0
What else can I help you with?
What is the number 2 position when turning the key on a Honda accord?
Accessory position. Radio will play but ignition is still off.
What do I do when my 2000 Chevy Malibu is in park and I can't turn my key to the off position and the key still comes out of the ignition switch?
The neutral safety switch is bad, the ignition does not recognize it is in park. Your ignition switch may be bad.
91 cavalier 3 1wont start changed ignition module and still wont start?
change the crank position sensor
Why can you Remove key from ignition while driving?
Removing the key from the ignition while driving can be dangerous and is generally not recommended, as it can lead to a loss of power steering and brakes, making the vehicle hard to control. In some vehicles with traditional ignition systems, turning the key to the "off" position can cut off the engine while still allowing the driver to steer, but this poses significant safety risks. Many modern vehicles have safety features that prevent the key from being removed while in motion. Always prioritize safe driving practices and avoid removing the key while driving.
I have a pin in the hole and I have the key in the ignition and I still cannot get the ignition cylinder out of my 2001 ford focus how do I get it out?
Answer The key has to be in the accessory position then you have to push hard on the pin as you are pulling on the key wiggling the key will help loosen it If key will not turn to accessory position you will have to drill out cylinder.If you don't want to do this a locksmith is cheaper than the dealer
Why does my Key fobs not work on a 2001 vauxhall astra?
If your batteries in the keyfob are OK then you need to synchronize your remote/s with the car using the following procedure:- 1, Ignition off 2, Key in ignition but leave ignition in off position 3, With key still in ignition press the lock button followed by the unlock button. If this doesn't work try again but with the ignition switched on (stage 2)
How can you reset the maintenece meter for c200 1998?
turn ignition to position 2 press 0 button twice within one second switch off ignition press and hold 0 button down and switch on to position 2 again still holding down 0 button after ten seconds will bleep job done
When you shift into park in a 96 grand am and you turn the key in the off position. The key ignition is still locked what could be the problem?
the shift interlock cable,sounds like the problem
Where is the cam position sensor on a 1998 chev 1500 pickup?
It does not have a cam sensor. That engine still use's the distributor to note the position of the cam. If it's not firing then you need to check the ignition module and pick-up coil, they are both in the distributor.
1999 Chevy Tahoe LT vortex ignition still making ding after removing key and making tick tick sound also no responce from starter at all?
Sounds like you need a new battery.
1997 Chevy S10 engine will crank no start - have fuel but no spark I have replaced the ignition coil ignition control module and crackshaft position sensor and still nothing new?
In case you haven't done so allready, check all the fuses under the hood and in the dash.
The ignition key is stuck in the ignition Does not feel like the ignition switch is going into the lock position This is a 06 Fusion?
remove the plastic ring around the button you push on the shifter to switch gears, the car thinks it's still in drive and won't release the key. The ring removal will release it, but the actual fix involves replacing the whole shifter...
