Yes.
You do not need a torque wrench when replacing brake pads and rotors. Some of the tools needed to change the rotors and pads are the c-clamp, sockets, wrench, grease, and brake cleaner.
depends on the condition od the pads. If worn or have groves etc from the rotors then replace.
WELL, I HAVE A 2005 TOYOTA SUV AND I JUST HAD MY FRONT ROTORS AND BRAKE PADS REPLACED AND IT COST ME 325.00. If you do it your self it is about 140.00
Don't know about calipers - have never needed to replace those. If you are replacing, yourself, the parts (pads and rotors) will cost anywhere from $120 up for front pads and rotors (pads $20 up for a full set, rotors $45 up each). If you check the web, there are some sites where you can order an entire set (pads and rotors) for around $90.
Check out this post: http://www.mavromatic.com/2007/03/diy-part-i-replacing-rear-rotors-and-brake-pads-on-a-land-rover-discovery-ii/
To stop bicycle disc brakes from squeaking, try cleaning the rotors and brake pads with rubbing alcohol or a specific disc brake cleaner. Also, check for any contamination or wear on the brake pads and rotors, and adjust the brake calipers if needed. If the issue persists, consider replacing the brake pads or rotors.
If the rotors are in good condition, not warped, not scratched, then you can replace the pads without turning the rotors. Inspect the rotors carefully.
In may area around $150.
Why do brake pads squeak after replacing pads?
That usually means that your brake pads are so worn that a metal part of the pad assembly is coming in contact with the rotor. Some brake pads have a "feeler" built in that causes you to hear a squeak when your pads are getting low without actually damaging the rotor. If your pads are digging into your rotors, you can usually have the rotors machined at least once without replacing them, as long as the gouge is not too deep.
It sounds like you have air in your brake lines. It sounds like you have air in your brake lines.
You have a warped rotor. Brake pads need replacing and the rotors turned or replaced.