To remove a seized speed sensor, pry it loose with a thin screwdriver and gently rock it back and forth while pulling with steady pressure.
Remove the wiring harness from your speed sensor. Remove the speed sensor retaining bolts. Reverse the process to install your new speed sensor.
Raise the vehicle and locate the speed sensor. Remove the electrical plug. Turn the speed sensor counterclockwise and remove it. Install the new speed sensor.
The speed sensor is mounted in the top of the rear differential on a 1999 F150. Remove the wires, then unbolt the sensor to remove it.
replacing speed senor is not a hassle. all you have to do is find SPEED SENSOR, all cars are different, in my honda theres 4, i have replaced two already. speed sensor should be on transmission. remove bolts and pull out. simple put in new sensor.
The speed sensor can be found on the side of the transmission and can be easily removed with a 9/16 ratchet. Remove the wiring harness from the speed sensor before removing the speed sensor from the transmission.
The speed sensor is found on the transmission of the 1992 Honda Civic. To replace the unit locate the mounting bolts and remove them. Unplug the wiring clip and pull the sensor off.
To change the Transmission Speed sensor, G68, remove battery and battery tray. The sensor is below the battery tray. A 10mm socket will remove the bolt that attaches sensor to transmission. Unclip plug and pull sensor out.
The speed sensor on a 1990 Chevy Celebrity is on the top of the transaxle on the passenger side of the car. To change it unlatch and remove the wire harness then remove the two bolts that hold it in. The speed sensor can then be lifted out of the transaxle. To reinstall a new sensor reverse these steps.
I need to know how to remove a rear wheel speed sensor on a 2002 Pontiac Sunfire
To remove the speed sensor on a 1999 Chevrolet S10, first, ensure the vehicle is parked on a level surface and the ignition is off. Locate the speed sensor, which is typically found on the transmission or transfer case. Disconnect the electrical connector by pressing the tab and pulling it off. Finally, use a socket or wrench to unscrew the sensor from its housing and remove it from the vehicle.
The speed sensor is located by the driver side transaxle on the transmission. 1- Disconnect the left driveaxle from the side gear shaft 2- Remove the speed sensor retaining bolt 3- Unplug the speed sensor electrical connection 4- Remove the speed sensor This is slightly more complicated than it appears. complete instructions can be found in a Haynes/Chiltons repair manual
if your talking about the vss or speed sensor it has to be done under vech after you remove cat.converters