To change the distributor cap and rotor on a 1987 Corvette L98 motor, first disconnect the negative battery terminal to avoid any electrical issues. Remove the distributor cap by unscrewing the retaining screws and carefully lifting it off, noting the position of the wires. Next, pull off the old rotor, which is typically secured by a single screw or may just lift off. Install the new rotor by securing it in place, then attach the new distributor cap, reconnect the wires according to their original locations, and finally reconnect the negative battery terminal.
The ignition module is located in the distributor under the rotor, it plugs in.
The ignition module is located in the distributor under the rotor, it plugs in.
Cap and rotor, yes. Points, no.
remove the distributor cap and grab the rotor then pull straight up.
Change it. Don't be a dumb.
buy a new distributor cap and rotor. Unscrew the distributor cap (on the drivers side of the engine block), take note how the existing rotor is sitting, remove it, and place the new rotor in the same position. Put on the distributor cap and screw it into place... very simple job. thats how you change the rotor......he asked about the distributor....try again.
mark position of old distributor on motor and on old dist, also mark position of rotor. Remove old distributor, mark the position on new distributor, move rotor to the marked position, drop in
Absolutely
mabey bad plug wires or plugs....or rotor in the distributor...but im 16 what do i know
change the rotor. spark shorting to distributor shaft
If it has a distributor it has to come out and be completely disassembled //its under the rotor!!!
Distributor and rotor.Distributor and rotor.