0
What else can I help you with?
Can the hazard switch keep the turn signals from working?
Not typically. answer yes the hazard lights stop turn sinals from working there are only 2 elements in the bulb one for stop and one for turn hazars use same eement as turns signals it is for that reason that it is illegal in most states to actually drive with your hazards working they are supposed to be used only when stopped
Why do the hazard lights stay on in dashboard?
If you will notice the hazard lights are not actually flashing, reason being, the hazard flasher relay is defective. Replace it.
What would make the brake lights and turn signals not work on a 95 Grand am?
Check the bulbs they are double filamented with the smaller for stop and turn signals
Why does hazard and turn signals don't work on 2005 mustang?
The common reason why is a fuse blew.
Why would the turn signals brake lights and hazard lights all quit at the same time on a 1991 Ford Explorer?
9 times out of 10, it's just a fuse, check your fuses be sure non are blown out, It has to have blown out for a reason, find any loose grounds, touching wires or wire damage.
What could be the reason for the tail lights and dash lights to go out when the turn signals are used on a 1997 Mazda LX?
There is a short somewhere in the wiring.
What could be the reason for the brake lights and blinkers not working on a 1996 Ford E-250 Van?
i had the same problem...turned out the hazard flashers button on top of steering column was in the wrong position ! ...talk about simplr..hope it works for you
When may you use harzard warning lights?
You may use you hazard warning lights when your car breaks down, you have a flat tire, or you need to pull over for any reason.
What causes the turn signals and hazard lights not to work on a 2001 daewoo Nubira?
If all of them have spontaneously gone out then it is likely a blown fuse. Look in the fuse box for hazard lights and pull the fuse out with the fuse puller. Then replace it with one of the same color (and probably the same number on the top). However, if your fuse is blown, there is usually a reason, which will cause it to soon blow again. There could be a short in your wires somewhere. But just replace the fuse and if it keeps happening then look into it more closely.
Is the TNS relay in the fuse box under the hood a 'turn signal relay' and if so could that be the reason the turn signals and emergency flashers will not work on a 1999 Mazda 626?
The TNS relay in my '99 626 is blown, causing the dash lights, front & back parking lights, and taillights to not work. Turn signals and hazard lights still work. Quick test: The A/C relay is exactly the same part. You can swap relays to check the TNS relay. Be warned that swapping relays can result in more damage if a short caused the first one to blow. Doc
What could be the reason for dash board lights and tail lights not working on a 1989 Mercury Sable even after the fuses have been replaced?
Is there a penny stuck in the lighter port?
Why are the interior lights to 2003 range rover are not working?
The most likely reason why the interior lights of a vehicle are not working is because a fuse has blown. That is especially true if all of them are not working. Get out your owners manual. See where the fuse box is located. Find the particular fuse, and replace it.
