0

Subjects>Auto>Auto Parts

What is the type of transmission fluid needed for a 1993 ford ranger five speed with hydraulic clutch?

Anonymous

∙ 20y ago

Updated: 10/22/2022

Generally 80W90 GL5 will work in any manual transmission. This is a multi-purpose transmission oil available at the mart stores or home centers, and any auto parts stores.

Wiki User

∙ 20y ago

What else can I help you with?

Related Questions

How do you unhook clutch hydraulic line for ford ranger from transmission?

You will need the Ford Hydraulic Clutch Quick Disconnect Tool.

Where is the clutch slave cylinder on a 1997 ford ranger?

The clutch slave cylinder for a hydraulic clutch is inside the manual transmission bellhousing

Where is the clutch slave cylinder found on a 1995 Ford ranger xlt?

The slave cylinder for your hydraulic clutch is inside the transmission bellhousing

Location of clutch slave cylinder of 1994 ford ranger?

The hydraulic clutch slave cylinder is inside the manual transmission bellhousing

Can you put brake fluid in a manual transmission?

Not in the transmission , but the hydraulic clutch on a Ford Ranger uses DOT 3 brake fluid

How do you remove the hydraulic clutch cable from the transmission on a 93 Ford Ranger 5 speed trans?

The hydraulic clutch slave cylinder is located on the mainshaft of the trans. You must remove the trans to get to it

Where is the slave cylinder on a 1997 Ford Ranger xlt?

The slave cylinder for a hydraulic clutch on a Ford Ranger is inside the manual transmission bellhousing

How do you adjust clutch on 1988 Ford Ranger 4spd with OD transmission?

you don't adjust it. It is a Hydraulic clutch unit. you have to bleed it. There is a 7/16" bleeder valve on the transmission. clay Colorado

Where is the slave cylinder on a 88 ford ranger?

The slave cylinder for a hydraulic clutch is located inside the manual transmission bellhousing

Where is a slave cylinder on a 95 ford ranger?

The slave cylinder for a hydraulic clutch is inside the manual transmission bell housing

Were is the bleeder for a clutch on a 1993 ford ranger?

On the drivers side of the transmission bellhousing Check out : www . the ranger station . com ( no spaces ) Click on Tech Library Under the manual transmission section they have a good write-up on how to bleed a hydraulic clutch

What kind of hydraulic fluid do you put in your Ford Ranger 2.3 for the clutch?

DOT ( 3 ) brake fluid is used for the hydraulic clutch in a Ford Ranger

Trending Questions

What is the difference between ic engine and ec engine? Should officer in charge be hyphenated? Where is the turn signal flasher relay fet13 for an Ford Falcon EL? Are exhaust manifolds the same for 350 olds and 455 olds? Hazard lights do not blink? What is the drive cycle for a 2000 Kia Sportage? Where can you see a diagram of a Jaguar headlight? How many quarts of fluid do you need to change 45rfe transission 2wd? What is the best oil to use for a 2002 Chrysler Town and Country with 204000 miles? Can you put transmission fluid in your power steering pump? How do you remove the rear bumper from a 1976 corvette? Does a dead battery affect the inside hood release on a 2006 Chrysler 300? Why was heated seats in a car invented? How do you change front brake rotors on a 1994 Ford F150 2WD? What SUV's have a timing chain? Where is the fuel filter on a 2002 Polaris sportsman 500 Ho? What is the firing order on 1988 or 1989 Volvo penta marine engine? Who invented the manual transmission? How do you remove overdrive solenoid? I need a 1990 Lincoln mark vii fuse box diagram?

Resources

Top Categories

Product

Company

Copyright ©2025 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.