It is in form of a drum . As the drum is rotated, series resistance is gadually cut off.
To create a wiring diagram for the electric start of an XG 470 electric scooter, you typically need to connect the battery, ignition switch, motor controller, and starter relay. The battery positive terminal should connect to the ignition switch, which then connects to the motor controller. The controller should have outputs for the electric motor and the starter relay, which engages the motor when the start button is pressed. For precise connections, refer to the scooter’s service manual or manufacturer specifications, as wiring can vary by model.
A bendix.
In DC series motor, field and armature are in series. so we use only two points. They are line and armature. therefore we use two point starter.
crawl under the car an remove it
Three phase motors are controlled by a device called a starter. The starter allows the motor's supply voltage to be applied to and removed from the motor. These types of starters coil's can be controlled with usually a lower voltage that can be remotely controlled.
A schematic diagram of a 3-point starter for a DC shunt motor includes a few key components: a starter handle, a series coil (or relay), and a shunt motor connection. The starter handle is connected to the series coil, which is in turn connected to the armature winding of the motor. The outgoing leads connect the motor's armature to the power supply, while the shunt field winding is connected to the power supply directly. The starter allows for a gradual increase in voltage and current to the motor, protecting it from inrush current during startup.
The problem is in the starter drive (sometimes called bendix). Take the starter back to wherever it was rebuilt and have it repaired or exchanged.
The starter motor is at the rear of the engine.
The starter motor is at the rear of the engine.
You can find the starter on the right hand side of the motor. The starter will be near the back of the motor. You can follow the positive battery cable to the starter.
Because it has three terminals L , F and A L - Line (connected to Supply) F - Field (connected to field of dc motor) A - Armature (connected to armature of DC motor) that's y it is called 3 point starter :)
The starter should be located at the rear of the engine next to the flywheel on the passenger side. ~ D