A slip yoke is when the end of the drive shaft in a RWD vehicle plunges in and out of [most likeley] transmission when rear suspension is flexed.
A slip yoke has a splined shaft the drive shaft slides over. This allows the drive shaft to flex on rough terrain. A flange yoke has a flat plate on the transfer case and the end of the drive shaft and they bolt together.
NO. It has a slip yoke.
The tailshaft housing and bushing
The only seals on the driveshaft itself would be on the slip yoke. You're probably thinking of the pinion seal, which is at the front of the differential, behind the input yoke to the differential.
First make drive shaft and yoke to insure tat they are replaced in the same location to maintain factory balance Remove small "U" bolts at yoke Pry drive shaft out of yoke Pull driveshaft off splined end
Remove 2 small u-bolts from rear end yoke Pry drive shaft out of yoke Slide front end of drive shaft off front splines
slip yoke seal
front drive shaft, how do you get the yoke out of the transfore case to replace the ceal?
The Welsh plug in the yoke is no longer sealed. The yoke will need replaced.The Welsh plug in the yoke is no longer sealed. The yoke will need replaced.
Mark driveshaft and yoke to install in same location to maintain factory balance Remove 2 small "U" bolts from rear end yoke Pry driveshaft out of yoke Slide off spline from transmission not all drive shafts are one piece. How you remove the center support bearing(carrier bearing) from the forward drive shaft?
Dealer, salvage yard, Ebay.........
the slip yoke goes into the rear transmission seal