answersLogoWhite

0

On a Chrysler the spec is .035 Amp or less. Other brands are similar. It can take 20 minutes for the computers to "time out".

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

When you turned the ignition key a click sound acured and then the ignition lights not on only the key light?

You have a flat battery.


Does leaving a keyless fobs in car drain battery?

No, not unless the ignition is turned on.


How do you troubleshoot a 1983 Dodge ignition?

Battery first. Will it start with a jump? Battery ok, then use a test light & see if you have current in the hot wire to solenoid when key turned. If you do, it's the starter. If not maybe the switch but start there.


What is celinoid?

The starter solenoid receives a large electric current from the car battery and a small electric current from the ignition switch. When the ignition switch is turned on, a small electric current is sent to the starter solenoid. This causes the starter solenoid to close a pair of heavy contacts, thus relaying a large electric current to the starter motor, which in turn sets the engine in motion.


When key is turned nothing happened and battery is good?

Defective ignition switch, or bad starter.


What would cause the car to keep running once ignition turned off if headlights were still on?

Headlights run off the battery not the ignition...


Why does the battery and parking brake light stay on dim when the car is turned off?

It's possible that you have a bad ignition switch. Normally, those lights won't turn on unless the ignition is turned to the "Run" position. A bad switch may be allowing current to flow through one or more contacts when it's not supposed to.


Which device contains high current contacts that connect the battery to the cranking mortor?

The device that contains high current contacts connecting the battery to the cranking motor is the starter relay or starter solenoid. When the ignition key is turned, the solenoid activates, closing the high-current contacts and allowing electrical current to flow from the battery to the cranking motor, which starts the engine. This component is crucial for the efficient operation of the starting system in vehicles.


Why would the battery light stay on after the ignition is turned off on a 1986 Nissan pickup?

The voltage reg is sticking and will run down the battery.


What could be wrong when alero wont start or make any sounds when ignition is turned?

battery is shot?


What caused a squeal and the car to stall when you turned on the defroster?

The defroster is drawing more electrical current than the alternator can produce. It could be that the belt is slipping and the battery is margianally low so that when you turn on the defroster the alternator can't keep up and the battery isn't able to provide enough current to keep the ignition operating.


What could cause an automatic S10 pickup to sometimes act as if the battery were dead when the ignition key is turned?

1) Check the battery cable connections. They should be clean & tight. 2) Check the connection at the starter. They should be clean & tight. A loose ground cable on the battery. Check ground cable on the starter.