answersLogoWhite

0

To replace the impeller on a 35hp Mercury outboard motor, first, ensure the engine is off and disconnect the battery. Remove the lower unit by unscrewing the bolts and disconnecting the shift linkage. Take out the old impeller from the water pump housing, clean the area, and then install the new impeller, ensuring it is oriented correctly. Reassemble the lower unit and reconnect the battery before testing the motor.

User Avatar

AnswerBot

3d ago

What else can I help you with?

Related Questions

How do you replace impeller in 2006 mercury 60 hp bigfoot 4 stroke?

Annually


What year and model is a 35hp Mercury outboard serial number A 184641?

A 35hp Mercury outboard, serial number A184641, 1985 year model.


How do you change the impeller on a 9.8 mercury outboard?

The impeller on a 9.8 Mercury outboard boat motor can be easily changed. Remove the retaining bolt. The impeller will come off. Reverse the process to install the new impeller.


Mercury Marine where is the impeller located on a 7.5 hp motor?

The water pump impeller on a 7.5 hp Mercury outboard, is located on top of the gearcase, and is driven by the driveshaft.


How much does a 35hp mercury outboard weigh?

The 35 hp Mercury outboard has a dry weight of 148-150 lbs., depending on year model.


What year is 35 hp mercury outboard serial number 6445947?

A 35hp Mercury outboard, serial number 6445947, would be a 1984 model.


What model year is a mercury 35hp outboard with serial number c201910?

The Mercury 35hp outboard with the serial number C201910 was manufactured in 1988. Mercury outboards typically use a coding system that includes the year in the serial number, and the 'C' prefix indicates that it was produced in that specific year. For precise identification, consulting Mercury's official documentation or contacting a dealer can provide additional confirmation.


What year is 35hp Mercury Outboard serial number A152966?

A 35 hp Mercury outboard, serial number A152966, would be a 1985 year model.


How do you replace a sears leaf impeller?

you feel the clown


How do you wire a 35hp Chrysler boat motor to make the water pump work?

You don't wire anything. the water pump is mechanical , consisting of a rubber impeller /impeller housing and copper tube running from the impeller housing to the engine block. The drive shaft runs from the gearcase through the impeller/impeller housing to the engine block allowing the intake of water to match the engine RPMs. if the water pump does not work it is most likely that the rubber fins broke off (extremely common for all outboards that are water cooled)


Where is the impeller on a 2.2hp mercury outboard?

right behind the prop, on the same shaft


How do you change the impeller on a 25 hp mercury outboard?

What year? It may require special tools.