Changing the trim angle of an outboard, causes the bow of the boat to raise higher, or drop lower, to the surface of the water. It is used most often to soften the ride in rough or choppy water, or to plane the boat out quickly.
To fill your Mercury Outboard Trim boat motor, lower your engine to a 45 degree angle, Make sure your boat is level. Remove fill screw, and add the amount of fluid required to fill.
it depends on your hull, your lower trim plate should ideally be in line with the line of the keel of your boat.
If you accidenty get the yellow/red striped wire and the red/violet wire mixed up or backwards,the trim will only make a clicking noise!
The length of a motor boat is not restricted
The tilting trim on your boat may be experiencing a hydraulic issue or a malfunctioning trim switch. When the boat is stationary, the hydraulic fluid can settle, allowing the trim to move up and down due to gravity or pressure changes. However, when you're moving, the pressure created by the water may prevent the trim from rising, possibly due to a blockage or leak in the system. It's best to check the hydraulic fluid level, inspect for leaks, and ensure the trim motor and switch are functioning properly.
The dry weight of an 1986 model, 70hp Johnson outboard, with tilt and trim, is 256 lbs.
Yes
Motor Boat Cruise ended in 1993.
Motor Boat Cruise was created in 1957.
Get the air out first..
Making the sound of a motor boat between a woman's breasts. See http://www.urbandictionary.com/define.php?term=motor+boat
My boat is a 1996 Four Winns Jet boat, and I am replacing a freeze break motor.