answersLogoWhite

0

The stator used on an outboard engine, generates voltage to power the ignition system. In most applications, an additional coil, incorporated within the stator assembly, supplies voltage to the charging system as well.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where can I find parts for an old mercury out board engine?

A boat shop


200 EFI Black Max mercury no power?

If the boat idles fine and revs fine in neutral in the water and idles fine on the trailer, however has no power when you stick it into drive and give it some throttle a common problem with some of these early Mercury V6's is in the stator. The only way to fix this is to replace the stator.


How do you check the stator on a boat motor?

In order to check the stator on boat, you need to have a multimeter. First you have to make sure that the spark plugs are not misfiring. If they are replace them and then restart the battery.


Does a seadoo challenger jet boat have an alternator?

Yes, the charge coil is mounted on the stator laminate, located under the metal cover, on the front of the engine.


What is the gas ratio for a mercury 7.5 hp boat engine?

50:1 i belive


Where are freeze plugs on a mercury 350 v8 boat engine?

Freeze plugs, also known as core plugs or expansion plugs, on a Mercury 350 V8 boat engine are typically located on the sides of the engine block. They can also be found on the cylinder heads, depending on the specific engine design. Their primary function is to protect the engine from damage due to freezing by allowing coolant to escape if it expands when frozen. To locate them, check the sides of the engine block and the rear of the cylinder heads for small, circular metal plugs.


Do you use leaded or unleaded fuel on mercury 115 boat engine?

You should use unleaded fuel in a Mercury 115 boat engine. Most modern outboard engines, including Mercury models, are designed to run on unleaded gasoline to prevent engine damage and ensure optimal performance. Always check the owner's manual for specific fuel recommendations for your particular engine model.


How late did GM continue to produce the 305 engine?

2003 for highway applications. It's still in production as a boat engine for Mercury Marine.


Where is the oil filter located on a 1996 mercury boat?

If it is a 2 cycle engine, it has no oil filter. If it is a 4 cycle engine, the filter is located under the engine cover.


What is the best bass boat engine?

Mercury outboards are best. Johnson Sea Striker series is good too.


Were do you hook a chain to remove mercury 150 outboard boat motor?

Mercury Marine uses a lifting eye that threads into the flywheel hub for mounting, and removing, the engine.


How do you fill with fluid mercury trim motor?

To fill your Mercury Outboard Trim boat motor, lower your engine to a 45 degree angle, Make sure your boat is level. Remove fill screw, and add the amount of fluid required to fill.