The air intake temperature sensor on an Oldsmobile Intrigue is typically located in the intake manifold or near the air intake duct. It may be mounted directly on the air filter housing or in the throttle body assembly. For specific locations, it's advisable to consult the vehicle's service manual or refer to an online repair guide specific to the model year.
where is the crank sensor located on a 2002 Oldsmobile intrigue 3.5
The coolant temperature sensor on a 2000 Oldsmobile Intrigue is typically located near the thermostat housing on the engine. It is often found on the intake manifold or engine block, depending on the specific engine configuration. To access it, you may need to remove any obstructing components, such as the engine cover or air intake duct. Always consult the vehicle's service manual for precise location details and instructions.
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue
The coolant temperature sensor on a 2002 Oldsmobile Intrigue is typically located near the engine block, specifically on the intake manifold or cylinder head. To find it, look for a small, cylindrical sensor with an electrical connector attached, usually situated near the thermostat housing. It's advisable to refer to a repair manual or diagram for precise location details if needed.
in front of the converter
On my 1998 Aurora with 4.0L v8, the air intake temperature sensor is located on the air filter housing on the driver's side of engine compartment.
The ETC sensor on the 2002 Olds 3.5 engine is located at the right rear of engine, below the throttle body at the head not the block.
Behind the front bumper in front of the radiator, kinda to the passenger side. Easier to see with the hood open.
On the air intake filter box
For 3.5l, remove starter.
Its either your cam shaft position sensor or the crank sensor.
looks like a normal sensor, I have a 2002 intrigue, it is located just above the starter, you have to take out the starter in order to take it out.