To reset the speedometer on an Omega watch, first, ensure the watch is fully wound or has sufficient battery power. Pull the crown out to the second position and turn it to set the hands to the desired time. If applicable, press the reset button or function pusher to zero the speedometer. Finally, push the crown back in to complete the reset process.
Hold the speedo reset buton down when tirning on ignition after about 30 seconds it will reset.
The timing light reset if i remember is behind the speedo. Remove the speedo head and clocks and look on the back. There should be a little jumper in some terminals and next to it there should be some empty terminals. Just remove jumper from one and put into other, this should reset timing belt light.
The timing light reset if i remember is behind the speedo. Remove the speedo head and clocks and look on the back. There should be a little jumper in some terminals and next to it there should be some empty terminals. Just remove jumper from one and put into other, this should reset timing belt light.
Disconnecting the speed sensor stops the speedo and odometer. The odometer has to be changed by a certified speedo repair shop.
A combination of pulling and pushing the 2 speedo buttons at the same time. This should reset the service light.
A combination of pulling and pushing the 2 speedo buttons at the same time
You will need to pull out the instrument cluster and swap a screw on the back of the speedo unti. Best thing is to totally remove the mechanism on the back of the speedo which is only there for the cam belt light and throw it away.
To reset the manual speedo T Belt light on a 2002 3L Diesel Hilux, turn the ignition key to the "ON" position without starting the engine. Press and hold the odometer/trip meter button until the T Belt light flashes and then turns off. Release the button, and the light should be reset. Finally, turn off the ignition to complete the process.
To reset the lock code of an Omega suitcase, first ensure the suitcase is closed. Locate the reset button or lever, usually found near the lock mechanism. Press and hold this button while setting your new code by turning the dials. Release the button to save the new code, and test it to ensure it works before using the suitcase.
Also some Vans have a small rubber Grommet on the clear plastic speedo (front). You pick it out and poke a small wire into the hole to reset.
If you meen the trip meter have the engine running press the right hand button at the bottom of the speedo until it goes to zero.
yes, but the speedo will need to be reset and the fuel milage will drop