A big one.
In order to draw the phase diagram for transformer operating at load with lagging PF and leading PF, you will need to know the equation for the transformer being load free. This constant will help you with the load bearing equation of Np/Ns=Vp/Vs=Is/Ip.
A transformer is fundamentally a set of coils; therefore, a transformer is an inductive load. However, by "transformer load", you seem to mean "the load that is connected to a transformer". Whether that load is inductive or capacitive depends mostly on what is hooked up to the transformer.
Hope this helpsAn "OFF-Load tap transformer" can only have it's tap adjusted when it is De-energized,while the "On-Load tap transformer" can adjust its tap under load conditions.Kind RegardsHammad KhanUniversity of Western AustraliaAnswerAn 'off load' transformer is one whose secondary is open circuited, and not supplying a load. An 'on load' (not 'load') transformer is one that is connected to a load.
the efficiency is maximum in a transformer when no load loss is equal to load loss.
The ratings state the limits on voltage and current for operating the transformer at full load. The rated voltage times the rated current gives the rated VA of the transformer. Transormers are not usually rated directly for power because this depends on the power factor of the load applied.
A transformer requires a 75-kVA minimum load in order to be set.
What is the problem of operating a on-load furnace transformer with center tap
First isolate the transformer
All transformers have a power rating given in kVA which determine the maximum load that can be connected to that transformer.
It isn't! A transformer operating at no load has a very low power factor.
In order to draw the phase diagram for transformer operating at load with lagging PF and leading PF, you will need to know the equation for the transformer being load free. This constant will help you with the load bearing equation of Np/Ns=Vp/Vs=Is/Ip.
A transformer is fundamentally a set of coils; therefore, a transformer is an inductive load. However, by "transformer load", you seem to mean "the load that is connected to a transformer". Whether that load is inductive or capacitive depends mostly on what is hooked up to the transformer.
There is no problem as such. Whether you would want to, or need to, is another matter.
Hope this helpsAn "OFF-Load tap transformer" can only have it's tap adjusted when it is De-energized,while the "On-Load tap transformer" can adjust its tap under load conditions.Kind RegardsHammad KhanUniversity of Western AustraliaAnswerAn 'off load' transformer is one whose secondary is open circuited, and not supplying a load. An 'on load' (not 'load') transformer is one that is connected to a load.
Anything that draws energy from a supply is a load. So you 'load' a transformer by attaching a lamp, a motor, etc., to the transformer's secondary windings.
Any transformer can be overloaded by applying a load above the capacity rating of the transformer.
A: a transformer will follow the rule of input output ratio with no load. As soon as a load is applied there will be changes in the ratio