Recombination of negative and positive charge carriers
The base controls the flow of electrons between the emitter and collector. A small current can control a larger current, which is the basic principle of using a transistor as an amplifier.
Hsjsjjs
The emitter, the base, and the collector are parts of a transistor.
base
Base of transistor is made thin just to get Collector current equal to Emitter current.
To know if a transistor is PNP or an NPN,the following should be verified:For a PNP transistor, the base-collector junction is forward biased while the base-emitter junction is reversed biased.For an NPN transistor, the base-emitter junction is forward biased while the base -collector junction is reversed biased.
The active region of a transistor is when the transistor has sufficient base current to turn the transistor on and for a larger current to flow from emitter to collector. This is the region where the transistor is on and fully operating.
A Unijunction Transistor is a transistor that acts solely as a switch.
Its is the emiiter base of the transistor voltage!
The emitter, the base, and the collector are parts of a transistor.
It depends on the transistor, you just have to look at the data sheet for the transistor.
A transistor has three leads, called the base, the collector, and the emitter. The voltage of the base (in relation to the ground) determines whether and how much current flows from the collector to the emitter. An NPN transistor can be off, meaning that there is no (or very little) voltage from the base; partly on, meaning that there is some voltage from the base; or saturated, meaning that it is receiving full voltage from the base. A saturated transistor allows the current to flow from the collector to the emitter unopposed; a partly on transistor provides some resistance; and a transistor that is off provides full resistance. A PNP transistor is similar to an NPN transistor except it performs the opposite function: when it is saturated, the current is fully resisted; when there is no voltage from the base, the current is not at all resisted; and when it is partly on there is some resistance. In sum, a transistor controls the flow between the collector and the emitter based upon the voltage of the base. this is carbage. a transistor is basicaly two diodes back to back base being common TO BOTH DIODES because of inpurity doping on purpose at the depletion region the transistor will control the current flow on the other diode. Once it reaches saturation both diodes conduct therefore current can flow in BOTH DIRECTIONS ACROSS IT.
Transistor increase the strength of a weak signal from the base
A Darlington pair uses two transistors connected to behave as a single transistor with a very high current gain (beta). Transistor-1 has its collector connected to the collector of transistor-2. Transistor-1 has its emitter connected to the base of transistor-2. The base of transistor-1 with the emitter and collector of transistor-2 is used as a single transistor.
A transistor has three leads, called the base, the collector, and the emitter. The voltage of the base (in relation to the ground) determines whether and how much current flows from the collector to the emitter. An NPN transistor can be off, meaning that there is no (or very little) voltage from the base; partly on, meaning that there is some voltage from the base; or saturated, meaning that it is receiving full voltage from the base. A saturated transistor allows the current to flow from the collector to the emitter unopposed; a partly on transistor provides some resistance; and a transistor that is off provides full resistance. A PNP transistor is similar to an NPN transistor except it performs the opposite function: when it is saturated, the current is fully resisted; when there is no voltage from the base, the current is not at all resisted; and when it is partly on there is some resistance. In sum, a transistor controls the flow between the collector and the emitter based upon the voltage of the base. this is carbage. a transistor is basicaly two diodes back to back base being common TO BOTH DIODES because of inpurity doping on purpose at the depletion region the transistor will control the current flow on the other diode. Once it reaches saturation both diodes conduct therefore current can flow in BOTH DIRECTIONS ACROSS IT.
No. A diode is not like a transistor, and a transistor is not like (two) diode(s). Taken in isolation, the emitter-base and collector-base junctions of a transistor appear to be diodes, but they are coupled together so that the base-emitter current affects the collector-emitter current.
A Darlington transistor is a composite transistor. The definition is a combination of two or more transistors that have the purpose of increasing the current gain.
base
If inceres the base voltage of transistor them it may be burn . The base volt may be 0.8v to 1.8 If it use as a amplifier