No, but transmission line act as a lpf
Pole and transmission line hardware is purchased by cable television and utility companies
Image result for Why phases in transmission line are transposed?Transposition is the periodic swapping of positions of the conductors of a transmission line, in order to reduce crosstalk and otherwise improve transmission. ... Transposition also equalizes their impedance relative to the ground, thus avoiding one-sided loads in three-phase electric power systems.
I assume you are wanting to know about balancing networks to a transmission line? If this is the case, you really need to get a book on networks and filters. The physical makup of the transmission line will impact this calculation. The basic idea is you want to match the impedance at the input (looking out of the transmission line) to the same impedance as the transmission line (say 50 or 75 ohms for typical coax), and the output impedance (looking out of the transmission line) to the same as well. This will result in maximum power transfer, minimum power reflection. If you want to know how to make a balancing filter to a transmission line, then you need to design the filter according to your requirements - chebyshev, minimum ripple, wide band, narrow band, etc; You may need to use transformers to isolate the transmission line from your power circuitry, and use this as a matching network. You could also use transistors to accomplish similar things (less isolation, though), depending on what you're trying to do.
yes its used in transmission line.fuse normally used in peravitiu in all electrical systeam
how to fix a transmission without taking it a part how to fix a transmission line
Well, there is no way of doing it without an overhead or underground transmission line.
what are you trying to improve???
the best and most safest tools are line spanners
The amp rating of a transmission line is the maximum current that can safely flow through the line without causing damage. This rating is based on the material, size, and design of the transmission line to ensure it can handle the electrical load without overheating or overloading. It is important to adhere to this rating to maintain the safety and efficiency of the transmission line.
Cut out bad section of fuel line and replace with flexible fuel line and hose clamps
J&B liquid weld Replace the line
Replace it
I had a similar problem and ended up replacing both the lines and the radiator.
There was no 1969 "super beetle" only the standard. And which line are you replacing the hard line or the flex line?
If the line is connected directly, without a banjo, or flare fitting, then you will have to loosen the line, unbolt the slave cylinder, and twist the slave cylinder to unscrew the line.
You can cutoff the rear brake line. You will no longer have rear brakes and the fluid will leak out. It is not recommended that can't off the rear brake line, without replacing it.