whenever steam is utilised as heating media, steam condensate is produced.This steam condensatecan be utilsed for steam generation at some other location and needs to be pumped, for pumping you need some intermediate storage of this condensate. For storing it we use condensate pot whose level can be controlled.
CondenSER is correct. CondenSOR is not a real word. Regards!
Unlike a static condenser (capacitor bank), the value of reactive power from a synchronous condenser can be continuously adjusted. A synchronous condenser also has other advantages over static condensers such as: - not being affecting by harmonics (some harmonics can even be absorbed by a synch condenser) - producing no switching transients
The reason why it is called a barometric condenser is because it makes contact and it is a long vertical pipe into which it condensates and cools the liquid flow to accomplish the removal of pressure. It is also stated that when the pump is used the system is called a low level barometric condenser.
condenser approach is heat transfer the water to gas of condenser efficiency is good less then below (2 F) the system is working good.
The condenser can be either outside or inside, depending on the type of system. In air conditioning systems, the condenser is typically located outside the building to dissipate heat. In some refrigeration systems, however, the condenser may be located inside. The placement of the condenser is crucial for the efficiency and effectiveness of the cooling system.
to splite the phase
no
no
An atmospheric condenser operates naturally at atmospheric pressure (1.013bar). A vacuum condenser operates at pressures below atmospheric and will use some sort of pump to provide a vacuum.
This device is a condenser.
The refrigerant is for the entire air conditioner system not just for the condenser units. First, this question is not specific! There is whole bunch air conditioner condenser. Each manufacture design different condenser capacity. I might come back to this question.
CondenSER is correct. CondenSOR is not a real word. Regards!
Remove any leaves or debris from the condenser fins, you can go over it lightly with a soft brush if you wish. Don't use high pressure air or water, as condenser fins bend easily. Use a fin comb to straighten any bent fins.
AKG 220 Condenser Microphone
Use a condenser, or desalinization.
Liebig condenser, Vigreaux column, Snyder column, West condenser, Allihn condenser, Graham condenser, Dimroth condenser, Friedrichs condenser. There are no shortage of these!
This depends entirely on your budget. Condenser mic can capture wide range of frequencies and thus it is recommendable.