answersLogoWhite

0

There is a cover on the very top of the engine. You will need a torx tip srewdriver of the proper size to access the three screws holding the panel covering the coils. Under the panel are the coils there are two bolts aprox. 9mm that need to be taken out to remove each coil.Unplug the power wires first). If there's eccesive oil in the holes then you need a new valve cover gasket (can cause problems if too eccesive). Hope this helped, Bud Sisto

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you Replace jaguar ignition coil?

To replace a Jaguar ignition coil, start by disconnecting the negative battery terminal for safety. Next, remove any components obstructing access to the ignition coils, such as the engine cover. Then, disconnect the electrical connector from the faulty coil and remove the retaining bolts. Replace the old coil with a new one, reconnect the electrical connector, and reassemble any parts you removed before reconnecting the battery.


How do you check ignition coil is ok 1997 jaguar xk8?

To check the ignition coil on a 1997 Jaguar XK8, first ensure the engine is off and disconnect the negative battery terminal. Use a multimeter to test the primary and secondary resistance of the coil; typically, the primary resistance should be around 0.5 to 1.5 ohms, while the secondary resistance should be around 6,000 to 15,000 ohms. Additionally, inspect the coil for any visible signs of damage or corrosion. If the readings fall outside these ranges or the coil shows physical damage, it may need replacement.


Why would the ignition coil on a 1997 Mitsubishi Montero not be getting electricity?

whi ignition coil wont jabe electrisiti on mitsubichi pk up and distributor


Where is the Geo Metro 1997 coil ignition placed?

Firewall Drivers Side


Where is the coil wire on a 1997 Oldsmobile bravada?

Assuming this vehicle has the 4.3 V6 engine, the coil wire is connected to the passenger side rear of the distributor cap and the other end is connected to the ignition coil on the top passenger side of the engine.


How many coil packs does a 97 jeep grand Cherokee have?

A 1997 Jeep Grand Cherokee has one ignition coil.


Where is the ignition coil on 1997 vw jetta?

Here is a photo of the ignition coil. It is in the engine compartment against the fire wall. if you find the distributor with 4 wires going to the spark plugs, follow the distributor center wire which plugs into the ignition coil. A new coil is about $150. Good Luck. Sorry, the photo didn't work. Search at "http://www.gprparts.com/OEMParts/vw.asp" for a 1997 Jetta igition coil to see the photo


How many coil packs are on a 1997 Ford Expedition?

On a 1997 Ford Expedition : The 4.6 has the Electronic Distributorless Ignition System ( EDIS ) It has ( 2 coil packs with four towers each for the spark plug wires ) ------------------------------------------------------------------------- The 5.4 has the Coil On Plug ( C.O.P. ) ignition system It has ( 8 ) individual coils


Where is the ignition control module located on a 1997 ford ranger 2.3L?

On a 1997 Ford Ranger 2.3L, the ignition control module is typically located on the driver's side of the engine compartment, near the firewall. It is mounted on the ignition coil bracket, which is situated on the side of the engine. To access it, you may need to remove some components for better visibility and reach.


How do you check out 1997 neon ignition coil?

take it to your near by auto zone. they will check it for free.


Where is the ignition coil in a 2006 Ford Freestar?

In a 2006 Ford Freestar, the ignition coil is located on top of the engine, integrated into the ignition coil pack. It is situated near the rear of the engine, close to the spark plugs. To access it, you may need to remove the engine cover and disconnect the wiring harness.


Where is the ignition coil located on my 1997 Nissan 200SX?

On a 1997 Nissan 200SX, the ignition coil is typically located near the engine's intake manifold, mounted on or near the cylinder head. Depending on the engine type, it may be positioned on the driver's side. To access it, you may need to remove some engine covers or components for better visibility. Always consult your vehicle's service manual for specific details and diagrams.