Access to the rear lights is gained from the inside of the car Pop out the two bungs on the upright, unscrew the two nuts located behind the bungs. Release the light unit, unclip the bulb holder, then replace the bulb.
if you open the boot there isa hex shaped bolt remove it and away you go
You need the near pair of the rear lights and a screwdriver to unscrew the screws if you want to change the rear lights on a Peugeot 607.
how do get rear wiper arm off fiat punto grande
Open trunk and pull carpeting back from the rear lights and you will see wing nuts, take the wing nuts off and pull the complete light assembly out to change the bulbs.
Yes, the Fiat Punto is typically equipped with two reversing lights. These lights are usually located on either side of the rear of the vehicle and activate when the car is shifted into reverse. This design enhances visibility for both the driver and pedestrians while reversing. However, it's always good to check the specific model year, as configurations may vary.
you need to clean the electric contacts on the rear lights, its just a earthing problem
the cluster nuts for the rear lights are located behind two plastic lugs located either side inside the back, there is one on top and one on the bottom you should have the plastic light removal tool with the jack that came with the car, remove the lugs with a screwdriver and you will see some plastic nuts, if you do not have the tool for them you can use a socket instead. once the two nuts are out unplug the wiring as you extract the light.
If you have a Fiat Punto 2000 S, there may not be any rear speaker cables, I know there wasn't in mine.
Remove the wing nuts from inside the trunk. Just pull the housing out after.
rafail khan
the #3 slot is for the parking lights #11 is for the warning lights #21 is for hazzard lights and #26 is the back up lights the #3 slot is for the parking lights #11 is for the warning lights #21 is for hazzard lights and #26 is the back up lights