For a Peugeot 306 1.4 (Y-reg), the timing marks are crucial for proper engine alignment during maintenance. The timing belt should align the camshaft and crankshaft marks; the crankshaft mark is typically at the bottom of the engine, while the camshaft mark is on the cylinder head. It's essential to ensure these marks are correctly aligned before replacing the timing belt to avoid engine damage. Always refer to the vehicle's service manual for specific diagrams and detailed instructions.
To find the timing marks for changing the cambelt on a Peugeot 306 (P-reg), first ensure the engine is at TDC (top dead center) on the first cylinder. The timing marks are typically located on the crankshaft pulley and the camshaft. Look for a notch or line on the pulley that aligns with a corresponding mark on the engine block. Consult a repair manual specific to your engine variant for precise locations and additional details.
What power steering fluid do I put in peugeot 306sw 05 reg
my peugeot 306 has a twin headlight on drivers side and a single unit on passenger is that normal
is it a hatchback or estate?
yes
you might need to change the battery
The timing marks, on your 1.6 liter engine, can be found on the front of the main pulley. The timing marks will be scattered around the outside of the pulley.
there is one hole next to block for bottom end timing then the cam is a 10 mil hole that lines up with the hole on the belt end there is a bolt behind the cam wheel toward the front of engine hope that helps
can you tell what are the marks for a rover 25 14 on a 52 reg for got to mark it up thanks
On a Renault Scenic 1.6L (X reg), the timing marks are typically located on the crankshaft and camshaft pulleys. You should find a mark on the crankshaft pulley aligned with a reference point on the engine block. The camshaft pulley will also have a timing mark that should align with a specific point on the cylinder head. It's essential to ensure these marks are properly aligned when replacing the timing belt to maintain engine timing.
hold the trip reset button in for a while and your clock will move, i had the same problem
1992