For cutting through metal pipes, it is recommended to use a hole saw that is slightly larger than the diameter of the pipe. This will allow for a clean and precise cut.
To close a hole in a pipe, first, clean the area around the hole to ensure proper adhesion. You can use a patch made of a suitable material like epoxy putty or a pipe repair clamp for temporary fixes. For a more permanent solution, consider cutting out the damaged section and replacing it with a new piece of pipe, using appropriate fittings and sealants to secure it. Always ensure the repair is pressure-rated for the type of pipe and fluid being transported.
One alternative method for cutting copper pipe if a pipe cutter is not available is to use a hacksaw. Mark the cutting line on the pipe, securely hold the pipe in place, and carefully saw through the pipe using the hacksaw. Be sure to wear safety goggles and work slowly to ensure a clean and precise cut.
The best method for cutting internal PVC pipes using an internal PVC pipe cutter is to first measure and mark the pipe at the desired cutting point. Then, insert the internal pipe cutter into the pipe and rotate it around the pipe to make a clean and precise cut. Be sure to follow the manufacturer's instructions for the specific pipe cutter you are using to ensure safe and effective cutting.
A saddle drain is a type of fitting that is used to connect a smaller pipe to a larger pipe in a plumbing system. It is typically used to create a branch connection for a new fixture, such as a sink or a toilet. The saddle drain is installed by cutting a hole in the larger pipe, attaching the saddle fitting over the hole, and then connecting the smaller pipe to the fitting. This allows wastewater to flow from the new fixture into the main plumbing system.
To repair a PVC pipe without cutting it, you can use a PVC repair coupling or a PVC repair epoxy. These products can help seal leaks or cracks in the pipe without the need for cutting and replacing the damaged section.
It can't be done without cutting the pipe
With a pipe cutter or cutting torch or a chop saw
diagonal cutting pliers
yes
responsibilities of pipeters are, check n ticknes of pipe, know how to read the blue prent, cutting pipe by cutting torches, granding, veveling of pipe, check n measurement
Possibly if there is little pressure in the pipe -(ie if it's a drain pipe) . For a pressure carrying pipe,I would cut out the hole and replace with a long coupling, or a short piece of pipe and 2 couplings.