Theres two 10mm bolts at the back of the engine... bottom of the manifold... open these... then theres 3 rubber hangers.... one either side of back box and one on the centerpipe in front of the petrol tank.
The best place to purchase a Peugeot 106 exhaust system is from your local mechanic. If that is not an option, eBay Motors is always a great option for car parts.
Yes
with a bar of soap
valve clearance is... inlet 0.20 exhaust 0.40
To remove the sump on a Peugeot 106, first, ensure the vehicle is securely raised and supported. Drain the engine oil and remove the oil filter. Next, detach any components obstructing the sump, such as the exhaust or crossmember, and then unscrew the bolts securing the sump to the engine block. Finally, gently pry the sump away from the engine, taking care not to damage the gasket or mating surfaces.
on my r reg 106 i drilled out the 2 rivits
In august my 1999 106 pipe broke at front end i needed full catalyst and exhaust. Cost for catalyst and pipe was �75 and exhaust was �24 before vat and fitting
its underneath the handbrake go under the car where the centre exhaust is there is heat shields remove them and its there a 13mm nut wind it in till cable tight but with a bit of slack onit job done
What's the question? Yes, a peugeot 106 has dashboard lights.
you haft to remove the bumper first to get to the bolts holding in the lights
No the Peugeot 106 is not considered vintage. This is true because the Peugeot 106 was made in the year 1991. To be a vintage car you have to be around for more the 20 years
No