Yamaha Blaster Inner Clutch Spring Torque(5 Bolts with Springs) 4.3Ft-Lb. (51.6In-Lb.) Also, Center Bolt 5.1Ft-Lb. (61.2In-Lb.)
35 ~ 46 Foot pounds of torque. Pressure plate bolts.
what is the torque for the bolts on the clutch springs for a trx 90/>
pressure plate to flywheel bolts - 15 to 24
The torque setting for the pressure plate on the clutch for an s10 2.2 is 33 foot pounds. The torque for the 4.3 is 29 foot pounds.
24 Foot Lbs on clutch cover bolts. 85 Foot Lbs on flywheel bolts. Use lock tight on both set of bolts.
i have replaced my clutch to 10.5 diemter ,can i re use the morso flywheel/clutch bolts
To change the clutch on a 2002 Yamaha 660 Raptor, start by removing the clutch cover bolts and taking off the cover. Disconnect the clutch cable from the lever and remove the pressure plate by unscrewing the bolts. Take out the old clutch plates and replace them with new ones, ensuring they are properly aligned. Reassemble by reversing the steps, making sure to adjust the clutch cable for proper tension.
To install a clutch on a Yamaha Raptor 660, first, remove the left side cover by unscrewing the bolts and taking off the cover. Next, remove the clutch springs and plates, then replace them with the new clutch components, ensuring they're properly aligned. Reassemble the side cover, torque the bolts to the manufacturer's specifications, and check the clutch lever adjustment before testing. Always refer to the service manual for specific instructions and torque values.
1974 yamaha dt 125
The clutch pressure plate bolts are torqued down to 19 Ft Lbs
The torque specifications for a Cummins ISX clutch typically range from 30 to 60 ft-lbs for the pressure plate bolts, depending on the specific clutch model and manufacturer. It's essential to consult the service manual for the exact torque values and sequence for your specific application. Always use a calibrated torque wrench to ensure accuracy when tightening.