0
Test Prod Scale meter Zero corrector Zero Ohms adjust Scale selector
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What is the total resistance of a 5-ohm resistor and a 10-ohm resistor in a parallel series?
2
What is the phase angle of an ohm inductor in series with an ohm resistor connected to a 5 KHz source?
You need to provide values of resistor and inductor etc to find the phase angle.
What is the volt drop across a 10k resistor with a 5 volt supply?
If there is nothing else in the circuit, then the voltage drop across the resistor will be the full supply voltage of 5 volts. The size of the resistor does not matter in this case - it will always be 5 volts.
How do you calculate multiplying factor in 3 phase 4 wire energy meter?
mf is ratio of CT ration of meter box to CT ration written on meter. ex: CT meter box: 30/5, Meter ct ration 1/1. MF : (30/5)/(1/1)= 6
What is the average height for a 6 year old white male in the US?
A meter.... or 1.2 meter....
A 5 ohm resistor a 10 ohm resistor and a 15 ohm resistor are connected in series to a 120 volt power source. What is the amount of current flowing between the 5 ohm resistor and the 10 ohm resistor?
The current would be about 20 volts.
Which is the correct voltage division setting for testing a throttle position sensor?
Volt meter should be in a 5 volt scale.
A 5 ohm resistor a 20 ohm resistor and a 25 ohm resistor are all connected in series to a 100 volt power source The current running through the circuit is?
E/R=I. 100/50=2 amps.
What is the answer if you divide a meter into 5 equal parts?
5*20 cm = 1 meter
A DC voltmeter has a resistance of 20000 ohms per volt What is the resistance of the meter if the range selection switch is set on the 250 volt range?
5 megohms
A 5 ohm resistor a 10 ohm resistor and a 15 ohm resistor are connected in series to a 120 volt power source What is the amount of current flowing between the 5 ohm resistor and the 10 ohm resistor?
3.0 or threeAnswerIt depends how they are connected.In series, ther total resistance will be 220 ohms and, so, the current will be 120/220 = 0.545 A.In parallel, ther total resistance will be 20 ohms and, so, the current will be 120/20 = 6 A.
What is the sensitivity of a voltmeter using 0 to 5 ma meter movement is?
S = 1/ Ifsd = 1/5mA = 200 Ohm / V
A student sets up a series circuit with four 1.5 volt batteries a 5-ohm resistor and two 1ohm resistors what is the total resistance in her circuit?
7 ohms (5+1+1)
How tall is Vanessa Volt?
Vanessa Volt is 5' 5".
What are the 5 voltages produced by an ATX or BTX power supply?
+12 volt , -12 volt, + 5 volt, - 5 volt, and + 3.3 volt.
What is the current in a 100 volt circuit with 25 ohms of resistance?
Using Ohm's law V:IR .I:V/R..I:100/5-20...I-20ampere
A 3 ohm 2 ohm and a 5 ohm resistor are in series What is the total resistance in ohms of the system?
10 Ohms.
