Well, the word "high" can have different meanings in various work-areas.
To an electronics specialist, "high" voltage can be anything above 5-10 V.
To a home-electricity-technician, "high" voltage is anything above 50 V.
To an electricity-company-technician, "high" voltage is anything above 230 V.
It is better to ask for a clarification each time you here the term "high voltage".
High voltage switch gear operates in the voltage range of 36 kV and above. Minimum oil circuit breaker, air blast circuit breaker and SF6 (Sulphur hexafluoride) circuit breaker are the three mostly used disconnects for high voltage switchgear.
How high is the voltage that is being used? With high enough voltage any current is dangerous.
When a light bulb is rated for 3.2 V it means that it is the maximum operating voltage to be applied to the bulb.
Cut-in voltage is the value of voltage at which appreciable current begins to flow when a pn junction is forward biased.
yes a capacitor can improve voltage by improving power factor
30 cm
The shop charges a $200 minimum. After that the price is up to the individual artists.
Minimum 2V. Some can run as high please check sheerled.co.uk/
that main resign is high voltage is voltage value is high that same time current value is very low. easy to transmission to long distance consumer(HT required consumer) end we have not voltage loss and current also and conductor cost is reduced that is conductor thickness low ,so current level is low
Spark plug voltage is high tension voltage, needed to jump a spark between the plus and minus poles. Needed tension is about a minimum of 10.000 Volt between the poles.
Typically, when the coil voltage on a relay is decreased gradually, the relay "hold" will release at a certain voltage. This is usually defined as the Drop-out voltage (defined at some minimum value). Now, in the case of latching relay, the Drop-out voltage is called the Reset voltage.
Regulation has to do with keeping the voltage at a desired value. This is often put in a per unit value, which you can think of as a percent of nominal. So if the desired voltage is 34.5kV, and the actual voltage is 33.8kV, the voltage is .98 per unit. There are regional and national rules on how low or high voltage can be. If the voltage strayes from this, it must be regulated back to an acceptable value.
the device oprates on the minimum voltage. in this voltage is called threshold voltage.
high...
The breakdown voltage of an insulator is the minimum voltage that makes it partially conductive electrically. On the other hand, the breakdown voltage in a diode refers to the minimum reverse voltage to cause it to conduct in reverse.
High voltage switch gear operates in the voltage range of 36 kV and above. Minimum oil circuit breaker, air blast circuit breaker and SF6 (Sulphur hexafluoride) circuit breaker are the three mostly used disconnects for high voltage switchgear.
i think it is high value resistance as it is used in Transformers to get the output voltage.